Drolo Twin Peaks Tremolo V3 User Manual

Twin Peaks Tremolo V3

drolo

Connecting and powering:

The power supply needs to be 9V/100ma center negative like the common BOSS power supplies:

Make sure the polarity of your power supply is correct or it will damage the pedal. Do NOT run at higher voltages.
Since the pedal has a digital microprocessor operating with high frequencies, you might hear some high pitched noise if
you use it together on the same power supply with other pedals (daisy chained) even when it is off. The noise can bleed
through the power supply into the other pedal’s signal. This is normal for such devices. It might not be the case in your
particular setup but if you notice that, I would suggest using an isolated power supply for the tremolo.

Controls:

ON : Turn on the effect or bypass it.

TAP: Tap in the desired tempo

Tremolo Type

 Classic : Bass and treble modulated in phase
 Harmonic : Bass and treble modulated out of phase
 Bass Only : Bass modulation only, with fix treble
 Treble Only :Treble modulation only, with fix bass

Tone : adjusts the balance between the bass and treble portions. Turn it fully CCW and only the bass comes out. Turn it

fully CW and you get only treble. In the middle you get both. If you turn down the depth completely you can use the
tone knob as a sort of EQ

Depth: Allows setting the depth of the modulation
Rate: Sets the speed of the modulation