Drolo Molecular Disruptor V 2.0 User Manual

Molecular Disruptor V 2.0

drolo

The Molecular Disruptor is a DSP based multi-effect pedal that can be loaded with 8 patches selected from the molecular
patches list: http://www.davidrolo.com/molecular-patches/
This list is regularly being updated with new patches.

These patches get programmed after the purchase and cannot be changed by the end user.

Connecting and powering:

The power supply needs to be 9V/100mA center negative like the common BOSS power supplies:

Make sure the polarity of your power supply is correct or it will damage the pedal. Do NOT run at higher voltages.
As the pedal uses a digital processor operating at high frequencies, you may hear some high pitched noise if you use it
together on the same power supply with other pedals (daisy chained) even when it is bypassed. The noise can bleed
through the power supply into the other pedal’s signal. This is normal for such devices. It might not be the case in your
particular setup but if you notice that, I would suggest using an isolated power supply.