Drolo Molecular Disruption Device Manual

Molecular Disruption Device

drolo

Connecting and powering:

The power supply needs to be 9V/60ma center negative like the common BOSS power supplies:

Make sure the polarity of your power supply is correct or it will damage the pedal. Do NOT run at higher voltages.
As the pedal uses a digital processor operating at high frequencies, you may hear some high pitched noise if you use it
together on the same power supply with other pedals (daisy chained) even when it is bypassed. The noise can bleed
through the power supply into the other pedal’s signal. This is normal for such devices. It might not be the case in your
particular setup but if you notice that, I would suggest using an isolated power supply.

pot_0, pot_1, pot_3: each of these pots controls a parameter of the selected patch, function will vary depending on

the selected patch

fdbck: usually serves as feedback, but depending on the patch it can also be used for other functions or

have no function

mix: pans from full wet signal on the left to dry signal on the right.

(note for certain patches, due to a comb filter effect when mixing dry and wet signals
that are too similar you might hear some strange phasing. These patches were usually meant to
be used wet only but you are of course free to mix with dry if you like the results)

patch selector: select one of the 8 loaded patches

Note: When you change to a different patch, any sample that was held in the previous patch will
be emptied

exp/pot_0 selector: defines whether you are using the actual pot for the pot_0 control or an expression input

also defines the state of the tap footswitch