DRIVEN CHAIN TOOL User Manual

DRIVEN PERFORMANCE PRODUCTS

WWW.DRIVENRACING.COM

866-5-DRIVEN

DRIVEN CHAIN TOOL

Instructions:

Breaking

Start by using a grinder or dremmel tool to grind off the the top of the pins on any chosen

1.
sideplate.
Take the cap off of the alignment bolt (DCT-014) and remove the push bolt (DCT-015). Install

2.
the 3.8mm push pin (DCT-006) with included spring (DCT-008) into the alignment bolt and
replace the push bolt.
Attach the lever to the chain tool base (DCT-016).

3.
Turn the alignment bolt until it makes contact with the sideplate of the chain.

4.
Using the lever turn the push bolt clockwise until you have successfully pushed the pin

5.
through the sideplate. (A 14mm wrench may also be used in place of the lever, excluding all
power tools)
Repeat steps 4-5 for the second pin.

6.

Riveting

Remove pin and spring from alignment bolt if installed...

1.
Remove cap from alignment bolt if installed...

2.
Attach the master link to the chain from the back side so the pins are facing towards you.

3.
Attach the press plate with two through holes (DCT-003) into the alignment bolt and attach

4.
solid press plate (DCT-002) to opposite side.
Turn the alignment bolt clockwise and press the masterlink top plate onto the masterlink

5.
itself. Over-tightening will cause damage to the o-ring seals. Under-tightening will not allow
for proper flaring of the pins.
Replace the solid press plate with flat anvil (DCT-011)

6.
Remove the push bolt (DCT-015) from the alignment bolt and insert the riveting pin (DCT-007)

7.
then replace the push bolt.
Turn the alignment bolt clockwise unitl it makes contact with the pin.

8.
Using the lever turn the pushbolt clockwise until the pin flairs. (A 14mm wrench may also be

9.
used in place of the lever, excluding all power tools)
Repeat on the next pin and you are done.

10.

See parts diagram on reverse side:

DRIVEN CHAIN TOOL

Chain Breaker and Riveting Tool

DRIVEN PERFORMANCE PRODUCTS

WWW.DRIVENRACING.COM

866-5-DRIVEN

DCT-001

DCT-002

DCT-003

DCT-004

DCT-005

DCT-006

DCT-007

DCT-008

DCT-009

DCT-010

DCT-014

DCT-015

DCT-016

DCT-012 DCT-013

DCT-011

Part#’s and Description

DCT-001: Push bolt cap
DCT-002: Press plate solid
DCT-003: Press plate through holes
DCT-004: 2.2mm Push pin
DCT-005: 2.9mm Push pin
DCT-006: 3.8mm Push pin
DCT-007: Riveting push pin
DCT-008: Spring

DCT-009: Anvil solid
DCT-010: Anvil through hole
DCT-011: Anvil flat
DCT-012: Handle
DCT-013 Lever
DCT-014: Alignment bolt

DCT-015: Push bolt
DCT-016: Base