Drive Medical RTL12061M User Manual

shower stool
with rotating seat

banco para ducha
con asiento giratorio

banc de douche avec
siège rotatifsiège pivotant

item # RTL12061M

Rev.1.08.25.14

EU Authorized Representative
Drive Medical LTD
Ainley’s Industrial Estate
Elland, West Yorkshire,
United Kingdom HX5 9JP

www.drivemedical.comwww.drivemedical.com

assembly instructions

rotating seat

Rotating

Seat

Receptacle

Leg

Height

Adjustment

Leg

Seat

Handle

Storage

Tray

Rubber

Tip

Weight Capacity: 450 lbs (204 Kg)

1. Remove contents from carton.

2. Lay seat upside-down on a flat surface. Insert each
receptacle leg into the the bottom of the seat.
Repeat for 3 other legs.

3. Turn the bath bench right-side-up. Attach the storage

tray by placing it between the legs and inserting the
cross braces into the receptacles on the white leg
collars.

adjusting leg height

1. To rotate seat, pull up on handle until seat is free
of one of the 12 locked positions and rotate to
desired position. Seat can rotate in both directions.

Note: Built into the seat frame are 12 locking positions
which will secure the seat in place to allow the user to
safely stand up from or sit down on the seat. Make sure
the seat is in one of the locked positions before standing
or sitting.

additional precautions

1. Inspect all parts for shipping damage before assembly.
If there is shipping damage - DO NOT USE. Contact
dealer/carrier for further instructions.

2. Make certain that the height adjusting snap buttons
fully protrude through the same respective hole
of each leg extension. This will ensure that the leg
extensions are securely locked in position and an
even height is achieved.

3. Check the rubber tips on the leg extensions for rips,
wear or if they are missing. Immediately replace any
or all if any of these imperfections exist.

4. All four leg extensions with rubber tips MUST touch
the floor simultaneously at all times.

5. DO NOT stand on chair.

1. Before use, adjust height of each leg to your specific
needs, making sure all legs are at the same height.
When desired height is reached, lock legs into place
by aligning buttons into proper holes.

2. To be sure legs are locked into place, push down on
or pull up on the legs.

Rev.1.08.25.14

NOTE: To maintain the beauty of the original finish, clean
with mild soap and rinse with warm water. Wipe bath seat
dry after each use.