Drive Medical RTL10266 User Manual
nitro rollator
nitro rollator
ambulateur nitro
item #s:
RTL10266
RTL10266BK
RTL10266WT
RTL10266-T
RTL10266BK-T
RTL10266WT-T
RTL10266-H
RTL10266BK-H
RTL10266WT-H
www.drivemedical.com
Rev.4.10.23.14
parts list
1
2
6
7
8
9
12
3
4
5
10
11
Item # RTL10266
WEIGHTCAPACITYLBSKG
1. Handgrip
2. Adjustable tubing handgrip
3. Rear reflector on handgrip
4. Brake lever
5. Interlock button for handgrips
6. Back Rest
Rev4.10.23.14
7. Seat
8. Bag
9. Front wheel
10. Brake adjust screw
11. Rear wheel
12. Safety bow
introduction
The Walking aid is suitable for a single user with limited mobility. The nitro is ideal for
indoor and outdoor use.
nitro includes:
1. Bag
2. Back Rest
3. Operating Instructions
unfolding the nitro
Position the Nitro on its
wheels. Open the red
safety bow and lift up
(figure 1). Press both pipes
from the seat downwards
until they interlock (figure
2).
1
height adjustment
Press the red release buttons for handgrips below,
as shown in figure 3, and pull the handgrip upwards
at the same time. As the handle moves, release the
button. This automatically locks in the next possible
height. Repeat this process until the desired height
is reached.
2
3
removing / attaching the carry bag
To remove bag, twist knobs located on the front end of the seat frame outward
(Figure 4 & 5). Pull out knobs and slide bag out of receptacle.
To replace bag, fold the Nitro slightly and reverse above steps.
4
braking / locking
Pull both brake levers upwards to apply the brakes
while the Nitro is moving (see figure 6). Always
brake slowly and steady.
Press both brake levers down to apply the locks
while the Nitro is stationary (see figure 7). Pull up
the brake levers and release to release the locks.
The effect of the brakes can be affected by
abrasion of the wheels.
Regularly test the brakes.
5
6
7
Rev4.10.23.14
adjustment of brakes
To adjust the braking
strength, adjust the
brake by pressing
the screw housing
downwards (figure 8)
and then turn left or
right (figure 9).
8 9
sitting
Position the Nitro on an even and solid surface. Lock
the brakes (parking position). The Nitro must stand
and must not slip. Sit straight up and do not lean
backwards. (See figure 10).
DO NOT MOVE ROLLATOR WHILE SEATED.
folding / transport / storage
10
To fold, pull seat
upwards by the handle
on the seat plate as
shown in figure 11. The
Nitro can now be folded
complete and secured
by using the red safety
clasp as shown in figures
12 and 13.
11 12
13
safety instructions
• Use only as a walking aid!
• Use only on even and solid surfaces.
• Maximum user weight: 300 lbs.
• Regularly check the screws and fasteners on the Nitro and retighten if necessary.
• Use bag only for transport of objects and do not overload. Maximum load: 11 lbs.
• Do not expose the product to temperatures above 104°F for an extended period
of time, as this can cause the Nitro parts to overheat and burn the user.
• Please make sure the Rollator is fully opened, seat is down and the folding bar
under seat is locked in the down position.
• Be sure that both knobs are fully tightened and are at equal heights. Test
Rollator for stability before applying full weight to hand grips.
• Test the brake lever before operating the Rollator. When wheels are locked, lock
bar on rear wheels should prevent wheels from turning. When locks are released,
the wheels should turn freely.
• Always lock the brake lever before sitting and do not use seat when unit is on an
incline or uneven ground.
• Replace tires when significantly worn or damaged.
• DONOTMOVEROLLATORWHILESEATED.This is a walking aid only
and is not to be used as a transportation device.
cleaning / maintenance
Clean regularly by hand with a damp cloth. Do not use aggressive detergents.
Rev4.10.23.14
Loading...