Drive Medical Bed Assist Handle Installation Instructions Manual

bed assist handle

barra de ayuda
para la cama

manche de lit pour
assistance à domicile

installation instructions

This Bed Assist Handle is designed for use with
most mattress and box spring type beds.

1. Remove contents from carton.

2. Remove mattress from bed.

3. Attach the hand brace (figure 1) to the base
support frame by depressing the brass lock
pins and sliding the hand brace into the
tubing (figure 2) until the lock pins “snap”
through the positioning holes.

figure 1 figure 2

6. Position the bed assist handle so that the
space between the vertical handle bars and
other bedside device or bed board must be
less than 2.36 inches (60mm), or larger than

9.25 inch (235mm).

7. Place bed assist handle so that the strap is
exposed on both sides of the bed (Figure 4).
Place mattress on bed.

8. Buckle the strap and adjust by tightening the
loose end of the strap (Figure 5).

figure 4

figure 5

4. Place assembled base support frame on top
of the box spring (Figure 3).

5. Unbuckle the strap and lay flat.

figure 3

WARNING

!

· This assist handle is intended for assisting in
and out of bed only. DO NOT use for other
purposes.

· Mattress must fit bed frame and assist handle
snugly to prevent potential patient entrapment.

· Follow installation instruction to prevent
potential patient entrapment.

· Patient entrapment may cause injury or death!