Drive Medical 10257BL-1 User Manual

Rollator

Andador

Déambulateur

EU Authorized Representative
Drive Medical LTD
Ainley’s Industrial Estate
Elland, West Yorkshire,
United Kingdom HX5 9JP

www.drivemedical.comwww.drivemedical.com

Assembly Instructions

Safety Precautions

Do not aempt to adjust or operate Rollator without

carefully reading all instructions in this manual.

1. First remove all contents from carton: backrest,
handle with tube, Rollator frame and Basket.

2. Open frame and slide padded backrest into frame
brackets making sure snap booms protrude
through holes.

3. Loosen tightening knob on handle receptacle and
insert handle tube into frame. The brake cable should
be positioned on outside of frame. Set handle to
desired height. Tighten knob by turning clockwise
until handle is securely in place. Make sure both
handles are set to the same height before use.

Orthodic

Height

Adjustable

Folding

Hinge for

Portability

Hand Grips

Backrest

Loop Locks

Safest System

Available

Wide

Comfortable

Seat

Hanging

Basket for

Functionality &

Storage

1. Please make sure the Rollator is fully opened, seat
is down and the folding bar under seat is locked in the
down position.

2. Be sure that both knobs are fully tightened and are at
equal heights. Test Rollator for stability before
applying full weight to hand grips.

3. Test the loop locks before operating the Rollator.
When wheels are locked (see illustrations for locking
and releasing locks below), lock bar on rear wheels
should prevent wheels from turning. If the wheels
turn while brakes are locked, please take unit back
to dealer for adjustment. When locks are released,
the wheels should turn freely.

4. Always lock loop locks before siing and do not use
seat when unit is on an incline or uneven ground.

5. Replace tires when significantly worn or damaged.

Important Safety Notice

Do not have anyone push you while you are seated on
the Rollator. This is a walking aid only and is not to be
used as a transportation device.

Loop Lock Operation

Always engage and disengage wheel locks on both sides
simultaneously.

1. To Slow Down or Come to a Temporary Stop — Pull
up slowly on the loop locks with four fingers until unit
slows down or comes to a temporary stop.

2. To Temporarily Lock Wheels in Position — Press down
on both loop locks with palms until you hear a “click”
that will tell you wheels are locked.

3. To Release Wheel Locks — Push up on both loop locks
with palms of hand to original position.