Drive 12025KD-1, 12025KD-2 User Manual

lifetime limited

warranty

Your Drive branded product is warrantied to be
free of defects in materials and workmanship for
the lifetime of the product for the original con­sumer purchaser.

bariatric

This device was built to exacting standards and
carefully inspected prior to shipment. This Lifetime
Limited Warranty is an expression of our confi­dence in the materials and workmanship of our
products and our assurance to the consumer of
years of dependable service.

This warranty does not cover device failure
due to owner misuse or negligence, or normal
wear and tear. The warranty does not extend to
non-durable components, such as rubber
accessories, casters, and grips, which are subject
to normal wear and need periodic replacement.

If you have a question about your Drive device or
this warranty, please contact an authorized Drive
dealer.

transfer bench

item #12025KD-1
#12025KD-2

EU Authorized Representative
Drive Medical LTD
Ainley’s Industrial Estate
Elland, West Yorkshire,
United Kingdom HX5 9JP

www.drivemedical.com

Rev.02.01.21.15

© 2015 Medical Depot, Inc. All rights reserved.

Drive is a trademark of Medical Depot, Inc.

Port Washington N.Y. 11050 USA Made in USA

www.drivemedical.com

assembly instructions

1. Remove contents from carton.

2. Lay transfer bench upside down on a flat surface.

3. Attach leg with the large suction cup by depressing
the brass push pin and inserting into the receptacle.
Repeat for second leg (Figure 1).
Note: These legs are inserted into the same side that
the arm support will be.

figure 1

4. Attach leg with small rubber tip by depressing brass
push pin and inserting into the receptacle. Repeat for
second leg (Figure 2).

5. To assemble backrest, insert pole into backrest
support and lock in place using attached locking collar.
Repeat for second pole (Figure 3).

figure 3

6. Insert backrest into base by sliding supports through
both receptacles and locking in place using attached
locking collars,
Note: backrest must go through both sets of
receptacles to become secure (Figure 4).

7. Turn transfer bench right-side-up. Attach armrest
by depressing brass push pins and sliding into the arm
receptacle on the side of the bench. Make sure the
arm arcs outward, not inward (Figure 5).

figure 5

NOTE: Back support is reversible to accommodate left or
right tub entry.

8. Place legs with suction cups into bath tub.

NOTE: Pull Tab on the suction cup to release from the tub.

Adjust legs to the need of the patient.

The transfer bench must be level to avoid damage or
injury.

Rev.01.05.05.14

figure 2

figure 4

Weight capacity: 500 lbs (227 Kg)