Drill Master 95527 Assembly And Operation Instructions Manual

DOOR LOCK

Model

95527

®

INSTALLATION KIT

ASSEMBLY AND OPERATION INSTRUCTIONS

Due to continuing improvements, actual product may differ slightly from the product described herein.

3491 Mission Oaks Blvd., Camarillo, CA 93011

Visit our website at: http://www.harborfreight.com

TO PREVENT SERIOUS INJURY, READ AND UNDERSTAND

ALL WARNINGS AND INSTRUCTIONS BEFORE USE.

Copyright© 2006 by Harbor Freight Tools®. All rights reserved. No portion of this
manual or any artwork contained herein may be reproduced in any shape or form
without the express written consent of Harbor Freight Tools.

For technical questions or replacement parts, please call 1-800-444-3353.

SPECIFICATIONS

1” Hole Saw Dimensions:
1-15/16” L X 1” OD

2-1/8” Hole Saw Dimensions:
1-15/16” L X 2-1/8 OD

Drill Bit: 2-5/32” L X 1/4” OD

Guide Template Dimensions:
5-7/16” L X 2-19/32” W X 2­11/16” H X 2-7/32” ID Hole

Drill Bit Mandrel Overall
Length: 3-7/8” L

Save This Manual

You will need this manual for the safety warnings and precautions, assembly, operating, inspection,
maintenance and cleaning procedures, parts list and assembly diagram. Keep your invoice with this manual.
Write the invoice number on the inside of the front cover. Write the product’s serial number in the back of the
manual near the assembly diagram, or write month and year of purchase if product has no number. Keep
this manual and invoice in a safe and dry place for future reference.

1.

2.

Use safety equipment. Always wear eye protection. Dust mask, nonskid safety shoes, hard

hat, work gloves and hearing protection must be used for appropriate conditions. Always wear

ANSI-approved safety goggles and a dust mask/respirator when using or performing maintenance

on this tool.

Maintain tools with care. Keep cutting tools sharp and clean. Properly maintained tools with

a sharp cutting edge are less likely to bind and are easier to control. Do not use a damaged tool.

Tag damaged tools “Do not use” until repaired.

SPECIFIC SAFETY RULES

1.

2.

3.

4.

When using a handheld drill (not included), always maintain a firm grip on the tool with both

hands to resist starting torque.

Avoid unintentional starting. Make sure you are prepared to begin work before turning on the

drill (not included).

Always keep any extension cord (not included) away from moving parts on the tool.

WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other con-

struction activities, contains chemicals known [to the State of California] to cause cancer,

birth defects or other reproductive harm. Some examples of these chemicals are:

Lead from lead-based paints.

Crystalline silica from bricks and cement or other masonry products.

Arsenic and chromium from chemically treated lumber.

Your risk from these exposures varies, depending on how often you do this type of work. To reduce

your exposure to these chemicals: work in a well ventilated area, and work with approved safety

equipment, such as those dust masks that are specially designed to filter out microscopic particles.

(California Health & Safety Code § 25249.5, et seq.) Unpacking

UNPACKING

When unpacking, check to make sure that the item is intact and undamaged. If any parts are miss­ing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon
as possible.

For technical questions, please call 1-800-444-3353.

Page 2SKU 95527