Headboard/Footboard Brackets
Contains Two (2) Brackets and Hardware
IMPORTANT NOTE:
Carefully remove all the parts from the carton. Arrange on a at
surface and verify you have all of the following parts and hardware.
PART AND HARDWARE LIST
A. Headboard Bracket
(2 pcs)
B. Support Bar
(2 pcs)
C. 1 3/4'' Screw
(6 pcs)
ASSEMBLY INSTRUCTIONS
STEP 1
STEP 2
D. Washer
(10 pcs)
TOOLS REQUIRED:
Phillips Screwdriver
E. Wing Nut
(6 pcs)
F. 1'' Screw
(4 pcs)
Hang the bracket (Part A) on the corner of the
frame for the desired width of your headboard.
Secure the bracket to the frame with 3 long
screws (Part C), 3 washers (Part D) and 3 wing
nuts (Part E). Hand-tighten the wing nuts.
Do not fully tighten to allow for side-to-side
adjustment of the bracket.
VIDEO
Scan the QR code on your smart phone or device, or enter the link below to watch
a complete video of the easy installation of the Headboard/Footboard Brackets.
https://www.youtube.com/watch?v=Ay1kU0oDs2w
Install the support bar (Part B) using 2 short
screws (Part F) and 2 washers (Part D). Fully
tighten all screws and wing nuts to solidly secure
the bracket to the frame.
Repeat the steps for the second bracket. Attach
your headboard to the brackets with the hardware
that came with your headboard (not included).
Loading...