Dream Support DSHOLCOWQN Assembly Guide
Platform Bed
Contains One (1) Bed and Hardware
IMPORTANT NOTE:
Carefully remove all the parts from the box. Arrange on a at
surface and verify you have all of the following parts and hardware.
PARTS LIST
TOOLS REQUIRED:
Phillips Screwdriver
A. Headboard and Footboard (2 pcs)
D. Center Support (1 pc)
B. Side Rail (2 pcs) C. Corner Leg (4 pcs)
E. Wood Slat System (1 pc)
F. Center Leg (3 pcs)
HARDWARE LIST
G. 40mm Bolt
(3 pcs)
A
H. Small Hex Key
(1 pc)
I. Large Hex Key
(1 pc)
J. 16mm Screw
(2 pcs)
K. 32mm Screw
(9 pcs)
(Continued on back)
ASSEMBLY INSTRUCTIONS
STEP 1 STEP 2
A
C
G
D
F
Attach the Corner Legs (Part C) to the Headboard (Part A)
and Footboard (Part A) by rotating the legs clockwise until
tightened. Attach the Center Legs (Part F) to the Center
Support (Part D) using 40mm Bolts (Part G) and secure
with the Small Hex Key (Part H).
H
Attach Side Rails (Part B) to the Headboard and Footboard
by sliding the brackets on the Side Rail onto the bolts of the
Headboard and Footboard. Secure with the Large Hex Key
(Part I)
I
STEP 3
J
STEP 4
D
E
K
D
Insert the Center Support (Part D) into the slots on the
Headboard and Footboard. Secure it using the 16mm
Screws (Part J) and a Phillips Screwdriver.
A
Roll out the Wood Slat System (Part E) and secure it in
place with nine 32mm Screws (Part K) using the pre-drilled
holes and a Phillips Screwdriver.
completely set up and ready for use.
Your Platform Bed is now
Loading...