Dream Support DSBLACKWEK, DSBLACKWTW, DSBLACKWQN, DSBLACKWDB, DSBLACKGDB User Manual

ASSEMBLY INSTRUCTIONS (CONTINUED)

STEP 4

N

K

R

F

C2

C1

Attach the Side Rail Legs (Part F) to the Side Rails (Part C1 and C2)
using 30mm Bolts (Part K) and Flat Washers (Part R). Tighten
using Large Hex Key (Part N).

F

STEP 5

Assembly Instructions

Contains One Bed and Hardware

A

C

B

Attach the complete Side Rails to the Headboard (Part A) and
Footboard (Part B) by sliding the side rail brackets onto the bolts
on the Headboard Legs (Part D) and Footboard (Part B). Do not
tighten yet.

STEP 6

N

L

H

I

Attach the Center Leg (Part I) to the Slat (Part H) using 35mm Bolt
(Part L). Tighten the bolt using Large Hex Key (Part N). Repeat this
process for all 4 Support Legs.

STEP 7

O

P

Place the four slats into the bed as shown. Tighten the bolts on
the headboard legs and footboard using Small Hex Key (Part O).
Secure the 4 slats using eight Screws (Part P) and a Phillips
Screwdriver. Your bed is now set up and ready for use.

A A

IMPORTANT NOTE:

Carefully remove all the parts from the box. Arrange on a at
surface and verify you have all of the following parts and hardware.

PARTS LIST

A. Headboard Top (1 pc) B. Footboard (1 pc) C. Side Rail (4 pcs)

TOOLS REQUIRED:

Phillips Screwdriver

ASSEMBLY INSTRUCTIONS

STEP 1

B

E

D. Headboard Leg (2 pcs) E. Footboard Leg (2 pcs)

G.

Side Rail Support (4 pc)

H. Slat (4 pcs)

C1 C2

F. Side Rail Leg (2 pcs)

I. Center Leg (4 pcs)

Unzip the black fabric on the back of the headboard and remove
the parts. Zip the black fabric closed after parts are removed.

N

Q

M

D

Attach Headboard Legs (Part D) to the Headboard (Part A) using three
50mm Bolts (Part M) and three Spring Washers (Part Q) per leg. Secure
tightly using Large Hex Key (Part N).

STEP 2

B

O

Attach the Footboard Legs (Part E)
to the Footboard (Part B) using two
50mm Bolts (Part M) and Large Hex
Key (Part N). Secure tightly.

A

D

STEP 3

M

N

D

N

HARDWARE LIST

J. 16mm Bolt

(8 pcs)

N. Large Hex Key

(1 pc)

A

O. Small Hex Key

(1 pc)

K. 30mm Bolt

(20 pcs)

L. 35mm Bolt

(4 pcs)

P. 32mm Screw

(8 pcs)

Q. Spring Washer

(6 pcs)

M. 50mm Bolt

(8 pcs)

R. Flat Washer

(8 pcs)

A

Attach the eight 16mm Bolts (Part J) to the headboard leg
brackets and footboard brackets using the Small Hex Key (Part O).
Do not tighten.

A

K

G

J

C2

C1

Attach the four Side Rail Supports (Part G) to the Side Rails (Part
C1 and C2) using twelve 30mm Bolts (Part K) and Large Hex Key
(Part N). Tighten the bolts.

(Continued on back)