Dreamsat Miller White Painted Bed Assembly Instructions Manual
Miller White Painted Bed
Assembly Instructions
Need assistance?
Call: 0344 292 0000
Dimensions mm Length Width Height
Small Double
2075 1338 1205
Approximate time to
assemble this product
Retain these instructions
for future reference
2 x people recommended to
assemble this product
Do not discard any of the
packaging until you have
checked that you have all the
parts and the pack of fixings.
You will require a cross
head screwdriver
Helpful advise before you begin:
1. We suggest you spend a short time reading through this leaflet
and then follow the simple step by step instructions.
2. If you follow the instructions carefully the end result should be
worth the effort.
3. Do not discard any of the packaging until you have checked that
you have all the parts and the pack of fittings.
4. Assemble this product on a carpet.
5. To ensure an easier assembly, we strongly advise that all fittings
are only finger tightened during initial assembly. Only upon
completion of the assembly should all fixing points be fully
tightened.
6. We recommend a periodic check on all fixing points to make
sure they remain fully tightened.
7. Keep glue and fittings out of children’s reach.
8. Do not use any other tools other than those recommended to
build this product.
9. Please do not use substitute parts. Use only additional or
replacement parts supplied by Dreams Ltd.
10. In the unlikely event that this product has missing or damaged
parts, please call 0344 292 0000 to obtain spares.
Page 1 of 9
2
1
Double
King
2075 1486 1205
2174 1638 1205
Page 2 of 9
Do not discard any of the
packaging until you have
checked that you have all the
parts and the pack of fixings.
Spanner
Fittings Checklist
Parts Checklist
Ø8 x 90mm Bolt
x 8
x 8
29 x 15 x 8mm Nut
Check size of fixings against this guage (dimensions in mm)
10
20 30 40 50 60 70 80 90 100 110
x 1
D
A
B
Ø8mm Nut
x 8
C
01 Head Board
Foot Board
Side Rail
02
03
01
02
03
03
Ø6 x 19mm Nut
Flat Washer
Note: The following fittings will be found
in the box which contains the Sprung
Frame,NOT the bed frames Assembly Kit.
Ø6 x 50mm Bolt
x 6
E
Allen Key M4
x 2
H
x 12
F
x 6
G
Center Leg
Center Leg
Ø8 x 50mm
Tapping Screw
x 1
I
Center Leg
x 2
M
x 1
J
x 1
L
M6 x 12mm Bolt
x 8
K
Allen Key
x 1
N
Page 3 of 9
Bed Frame Assembly
1
2
x 8
Ø8 x 90mm Bolt
A
Please fully tighten the
bolts by hand
Note: Please be careful of the Headboard or
Footboard falling down when attaching the
side rails.
A
01
02
01
02
03
03
x4
x4
A
Loading...