DREAMS Yardley Single Ottoman, Yardley Double Ottoman Assembly Instructions Manual
Yardley Single Ottoman
Assembly Instructions
Need assistance?
Call: 0344 292 0000
Dimensions mm Length Width Height
Single
2040 1010 910
Approximate time to
assemble this product
Retain these instructions
for future reference
2 x people recommended to
assemble this product
Do not discard any of the
packaging until you have
checked that you have all the
parts and the pack of fixings.
You will require a cross
head screwdriver
Helpful advise before you begin:
1. We suggest you spend a short time reading through this leaflet
and then follow the simple step by step instructions.
2. If you follow the instructions carefully the end result should be
worth the effort.
3. Do not discard any of the packaging until you have checked that
you have all the parts and the pack of fittings.
4. Assemble this product on a carpet.
5. To ensure an easier assembly, we strongly advise that all fittings
are only finger tightened during initial assembly. Only upon
completion of the assembly should all fixing points be fully
tightened.
6. We recommend a periodic check on all fixing points to make
sure they remain fully tightened.
7. Keep glue and fittings out of children’s reach.
8. Do not use any other tools other than those recommended to
build this product.
9. Please do not use substitute parts. Use only additional or
replacement parts supplied by Dreams Ltd.
10. In the unlikely event that this product has missing or damaged
parts, please call 0344 292 0000 to obtain spares.
Page 1 of 7
1/2
Page 2 of 7
Do not discard any of the
packaging until you have
checked that you have all the
parts and the pack of fixings.
Fittings Checklist
Parts Checklist
A
B
C
E
F
G
H
I
J
D
K
L
M
before assembly the bed, please open
the zipper at the back of headboard
and find the hardware pack(fittings A-R),
footboard(03),bottom cover(05) and bar
slats(10) here.
x1Strap
x8Bolts (M8x25)
x8Bolts (M8x20)
x2Metal Brackets
x8Bolts (M8x45)
x4Feet
x4
Nuts
x8
Nuts (M8)
x16Flat Washers (M8x20)
x4
Screws (Ø4x25)
x1Allen Key (M8)
x1Spanner (M8)
Black Soft Mat x2
Check size of fixings against this guage (dimensions in mm)
1 0 2 0 3 0 4 0 5 0 6 0 7 0 8 0 9 0 1 0 0 1 1 0
01020304050607
Page 3 of 7
Bed Frame Assembly
2
x 8
Bolts (M8x25)
B
Philips head screwdriver
ADDITIONAL TOOLS
(not supplied)
x 1
Allen Key (M8)
L
1
D
x 8
Bolts (M8x20)
x 2
Metal Brackets
D
Black Soft Mat
x 2
I
CCC
Loosely insert bolts (B) into each side of headboard (1) and foot board (2). Note: Do not tighten fully but leave 10mm
protruding.
Attach the side rails to the headboard and footboard. Make certain the bed is squared up, then tighten all bolts fully.
Attach the corner brackets to the headboard and footboard. Stick the black soft mat on the corner brackets.
010102020202030404
04
BBB
B
I
L
Loading...