Dreams Westbrook User Manual
WESTBROOK BED (APPLY TO DOUBLE)
Assembly Instructions
Dimensions mm Length Width Height
Double
Need assistance?
Call: 0344 292 0000
2010 1406 1150
Helpful advise before you begin:
1. We suggest you spend a short time reading through this leaflet
and then follow the simple step by step instructions.
2. If you follow the instructions carefully the end result should be
worth the effort.
3. Do not discard any of the packaging until you have checked that
you have all the parts and the pack of fittings.
4. Assemble this product on a carpet.
5. To ensure an easier assembly, we strongly advise that all fittings
are only finger tightened during initial assembly. Only upon
completion of the assembly should all fixing points be fully
tightened.
6. We recommend a periodic check on all fixing points to make
sure they remain fully tightened.
7. Keep glue and fittings out of children’s reach.
8. Do not use any other tools other than those recommended to
build this product.
9. Please do not use substitute parts. Use only additional or
replacement parts supplied by Dreams Ltd.
10. In the unlikely event that this product has missing or damaged
parts, please call 0344 292 0000 to obtain spares.
Page 1 of 8
You will require a cross
head screwdriver
2 x people recommended to
assemble this product
Approximate time to
assemble this product
Retain these instructions
for future reference
Do not discard any of the
packaging until you have
checked that you have all the
parts and the pack of fixings.
Parts Checklist
Do not discard any of the
packaging until you have
checked that you have all the
parts and the pack of fixings.
02
03
03
01
01 Head Board
Foot Board
02
03
Side Rail
Fittings Checklist
M6 x 20mm Bolt
A
M5 x 21mm Bolt
B
M5 x 13mm Bolt
C
Ø16 Metal Washer
D
Ø21 Metal Washer
E
x 8
x 4
x 6
x 14
x 6
Inner Bolt
Ø24 Rubber Washer
Ø5 x 43mm
Tapping Screw
Center Leg
Allen Key
F
G
H
N
I
x 6
x 8
x 1
x 1
x 2
Note:The following fittings will be found
in the box which contains the Sprung
Frame,NOT the bed frames Assembly Kit.
M6 x 12mm Bolt
J
x 8
Center Leg
K
x 1
Center Leg
x 2
L
Allen Key
M
x 1
Check size of fixings against this guage (dimensions in mm)
10
20 30 40 50 60 70 80 90 100 120
Page 2 of 8
Bed Frame Assembly
1
01
Fully Tighten bolts when the
bed frame is assembled
and in position
03
D
G
03
A
N
02
M6 x 20mm Bolt
A
2
x 8
Ø16 Metal Washer
D
x 8
Ø24 Rubber Washer
G
x 8
N
Allen Key
x 1
Page 3 of 8
Loading...