DREAMS Vienna Bed Assembly Instructions Manual

IMPORTANT NOTICE
OTTOMAN OPERATING INSTRUCTIONS
Once your bed frame is completely assembled the slat unit will not operate correctly unless a mattress is placed on the slat unit. Position the mattress on the slat unit whilst it is in the closed position.
When lowering the slat unit for the first time, take care to make sure it does not rub unevenly on the inside face of the side rails. If it does, the bed has been assembled slightly out of square. This can be reflected by moving the foot end of the bed slightly to the left or right whilst leaving the head end stationary.
PISTONS
The pistons used in the construction of this product are extremely strong and cannot be operated by hand when taken off the ottoman. All pistons are tested for correct pressure and operation before being attached to the slat unit.
Initially it might appear that the pistons are very stiff when opening and closing the ottoman – THIS IS PERFECTLY NORMAL
After operating the ottoman a few times, the movement of the pistons and the opening and closing of the ottoman will become easier.
WARNING
For the safety of yourselves and others, please ensure that:
Only the handle is used when lifting and lowering the frame. Failure to comply with this warning may result in injury and finger entrapment.
The handle is attached and always left visible on the outside of the bedstead frame.
The metal frame is fully raised in the ‘Up’ position before using the ottoman space,
otherwise the frame could fall causing injury.
Children and pets are not left unattended when the frame is in the lifted position as they could become trapped inside the ottoman space.
Please keep children and pets away from the ottoman bedstead whilst opening and closing the slat frame to avoid injury.
13x8
17x8
Footboard end
Headboard end
Loading...
+ 4 hidden pages