Dreams Sherbrooke Bedstead User Manual
DOUBLE 231-00031 (Solid slats)
231-00032 (Sprung slats)
KING 235-00031 (Solid slats)
SHERBROOKE BED
Assembly Instruction
Minimum No.of people
recommended to assemble
this product
235-00032 (Sprung slats)
Approx assembly time
Before you
start,here
is some
helpful advice
We suggest you spend a short time reading through this leaflet and 1.
then follow the simple step by step instructions.
If you follow the instructions carefully the end result should be worth 2.
the effort.
Do not discard any of the packaging until you have checked that you 3.
have all the parts and the pack of fittings.
To ensure an easier assembly, we strongly advise that all fittings are 4.
only finger tightened during initial assembly. Only upon completion of
the. Assembly should all fixing points be fully tightened.
We recommend a periodic check on all fixing points to make sure they 5.
remain fully tightened.
Keep glue and fittings out of children’s reach.6.
In the unlikely event that this product has missing or damaged parts, 7.
please call 0844 292 0000 to obtain spares
Page 1 of 6
PARTS
Fittings
A
1(1 piece)
5(2 pieces)
4(1 piece)
3(2 pieces)
2(1 piece)
M8 x 20mm x 8pcs.
B
Ø3.5 x 25mm x 2pcs.
C
Allen key 4mm x 2pcs.
D
M6 x 38mm x 6pcs.
E
M6 x 22mm x 4pcs.
F
Ø4 x 40mm x 6pcs.
G
Note:
M6 x 6pcs.
The following fittings will be found in the box which contains the Sprung
H
M8 x 4pcs.
Frame, NOT with the bed frames Assembly Kit.
PLEASE DO NOT USE THE FOLLOWING HARDWARE FOR THIS BED!
IK
Center leg x 1pc.
C
G
Center leg x 2pcs.
M6 x 12mm x 8pcs.
Allen key 4mm x 1pc.
Page 2 of 6
Loading...