DREAMS FLORENCE Assembly Instructions Manual
1 of 4
FLORENCE DOUBLE BED
Assembly Instructions
NOTE: It will require two people to assemble this bed. Assembly should be carried out in the room that
the bed will be used in.
3ᇬ43
1. We suggest you spend a short time reading through this leaflet and then follow
the simple step by step instructions.
2. If you follow the instructions carefully the end result should be worth the effort.
3. Do not discard any of the packaging until you have checked that you have all
the parts and the pack of fittings.
4. Assemble this product on a carpet.
5. To ensure an easier assembly, we strongly advise that all fittings are only
finger tightened during initial assembly. Only upon completion of the assembly
should all fixing points be fully tightened.
6. We recommend a periodic check on all fixing points to make sure they remain
fully tightened.
7. Keep glue and fittings out of childrenʼs reach.
In the unlikely event that this product has missing or damaged parts, please call
to obtain spares
Before you Start
here is some
helpful advice.
Minimum No. of people
Recommended to assemble
This product.
Approx assembly t ime:
X
2 of 4
Component parts and fittings contained in the box
PARTS Fittings
A
B
C
D
E
F
G
H
I
4MM Allen key 1pc
M6 x 35 Bolt 6pcs
M6 x 22 Jcn Nut 6pcs
Spanner 1pc
2 pieces
Ø8 mm Washer
8pcs
Ɏ8 spring washer 8pcs
Rubber washer 8pcs
5MM Allen key 1pc
1 piece
1piece
M8 x 25 mm Bolt
8 pcs
Part No: 000 - 1234
Part No: 000 - 2345
Part No: 000 - 3456
Loading...