DREAMS Cooper Ottoman King Bed Assembly Instructions Manual
Cooper Ottoman King Bed
Assembly Instructions
1. We suggest you spend a short time reading through this leaflet and then follow
the simple step by step instructions.
2. If you follow the instructions carefully the end result should be worth the effort.
3. Do not discard any of the packaging until you have checked that you
have all the parts and the pack of fittings.
4. Assemble this product on a carpet.
5. To ensure an easier assembly, we strongly advise that all fittings are only
finger tightened during initial assembly. Only upon completion of the.
Assembly should all fixing points be fully tightened.
6. We recommend a periodic check on all fixing points to make sure they remain
fully tightened.
7. Keep glue and fittings out of children’s reach.
In the unlikely event that this product has missing or damaged parts, please call
03442 920000 to obtain spares
Before you
Start, here
are some
helpful
advices.
Revision number 1/1
Revision number 1/1
PARTS
Fittings
NO. PART LIST QTY
(1) HEADBOARD 1
(2) FOOTBOARD 1
(3) SIDE RAILS ( R&L ) 2
(4) BOTTOM BOARDS 2
(5) GAS LIFT ( R&L ) 2
(6) SIDE RAIL SUPPORT 2
(7) RAILS ( R&L ) 2
(8) CENTER RAIL 1
(9) CENTER RAILS 2
(10) TUBING SLATS 2
(11) SLATS 32
(12) FABRIC PULL HANDLE 1
A
C
I
J
L
K M
M8×20mmx
16
pcs
B
M6×25mmx
12
pcs
M
8×30
mmx
6
pcs
D
M
6×40
mmx
18
pcs
EM4
Allen key ×
1pc
F
M5Allen key × 1pc
H
11
Spanner
× 1pc
M8 Washer x
22
pcs M6 Washe
r x36pcs M6 NUT
x6
pcs
Centre Cap x 16pcs
Side Cap
x32pcs
ASSEMBLY
STEP 1
Revision number 1/1
(1). Use bolt (A), Washer (I) to fix
the Side rails 3 to Headboard 1
and Footboard 2 by using Spanner
( F ) .
F
MAKE CERTAIN THE BED IS
SQUARED UP, AS SHOWN ON
THE RIGHT.
Once all four corners are located,
make sure the bed is still square
as in the sketch, then tighten all the
bolts 100% using Allen key (D).
Loading...