DreamGEAR DGWII-1190 User Manual

Package Contents:

Neo Fit
Power Fit
User’s Guide/Warranty Card
Registration Card

2 in 1

Neo Fit Workout Kit

USER’S GUIDE

USING THE NEO FIT:

To Put On:

1. Lift up the Wii Balance Board and put it on its short side with the
top of the Wii Balance Board facing towards you.

2. Slide the first elastic strap of the Neo Fit over the legs of the Wii
Balance Board. Do the same with the other 3 elastic straps until
the Neo Fit is completely on the Wii Balance Board.

To Take Off:

1. To release the Neo Fit, lift up the Wii Balance Board and put it on
its short side with the top of the Wii Balance Board facing
towards you.

2. Slide the first elastic up and over the legs of the Wii Balance
Board. Do the same with the other 3 elastic straps until the Neo
Fit is completely off the Wii Balance Board.

USING THE POWER FIT:

1. Plug the USB power cable into an available USB port on your
Wii console or any other device that has a powered USB port.

2. Remove the door from the Wii Balance Board and insert the
Power Fit with the “teeth” end going in first. Confirm the Power
Fit is securely attached to the Wii Balance Board.

3. To remove, press the release tab and lift the Power Fit up and
out of the Wii Balance Board.

www.dreamgear.net

TROUBLESHOOTING:

Problem: The Power Fit is not powering my Wii Balance Board.

Solution: Make sure that the Power Fit is inserted into the Wii

Balance Board properly and securely. Make sure that there is no
debris hindering proper placement of the Power Fit.

FOR TECHNICAL SUPPORT

or [e-mail]

www.dreamgear.net

PLEASE CONTACT: 1-877-999-DREAM