DreamGEAR DGPS4-6430 User Manual

Essential Gaming Kit

for PS4

™

User guide

Guide de l'utilisateur

Guía de usuario

www.dreamgear.com

ENGLISH

Includes

Dual Charge Station, Broadcaster Headset, 1 Amp USB AC
adapter, Micro-USB power cord, and user guide

Please read and follow this user guide thoroughly before
using the Essentials Gaming Kit.

How to use the Dual Charge Station

1. Gently plug the Micro-USB end of the included USB power

cord into the back of the Dual Charge Station.

2. Plug the USB A end into the included USB AC adapter.

3. Plug the USB AC adapter into a powered outlet.

4. Gently place your PS4 controller upside down on the Dual

Charge Station in one of the two designated PS4 controller
charge ports.

5. When charging, the LED will light up white. When fully
charged, the LED will turn o.

How to use the Broadcaster Headset

1. Plug the 3.5mm plug of the Broadcaster Headset into the

boom of the DualShock®4 controller.

2. Put on the headset and adjust the microphone to t properly.

NOTES:

• Make sure that the Broadcaster Headset is worn properly at
all times. Do not place the headset around the back of your
head, it must be worn over the top of your head. Make sure
that you allow the microphone to be positioned about one
inch om your mouth.

• Once the headset is ready for online chat, please refer to your
PlayStation 4 console’s User Guide for seing up the accessory.

Broadcaster Headset controls

To adjust the volume

• To raise the volume, turn the volume dial (marked VOL)
towards the + (plus sign).

• To lower the volume, turn the volume dial (marked VOL)
towards the – (minus sign).

Mute switch

Volume dial

To use the mute switch

• To mute the microphone, slide the mic switch (marked MIC)
towards “MUTE”.

• To unmute the microphone, slide the mic switch (marked
MIC) towards “ON”.

NOTE: When the microphone is switched to “MUTE”, other
players cannot hear your conversation, but you will still be
able to hear them speaking.

Troubleshooting

Issue: Controller will not charge.
Solution: Try the following:

• Reposition controller on dock until the LED indicator light
turns on.

• Verify all dust and debris is removed om device and dock.

Warnings

• Extended exposure to high volumes when using a headset
may result in temporary or permanent hearing loss.

• Prevent damage to your headset by not siing or stepping
on the headset, its cable or the cable connector.

Important safety precautions

• Do not aempt to disassemble product.

• Tampering with the product can result in damage to your
product, void of warranty, and could cause injuries.

• Store and operate between 32°F – 113°F.

• Do not allow this product to have contact with liquids.

• Do not place this product near a heat source or ame.

• Do not throw or shake.

• Do not operate if it has been subjected to shock or damage.

• Use so cloth to clean the exterior. Do not use harsh
chemicals or strong cleaning solvents.

FCC information

This equipment has been tested and found to comply with the
limits for a Class B Digital Device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate
radio equency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment o and on, the user is encouraged to try to correct
the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the distance between the equipment and receiver.

• Connect the equipment to an outlet on a circuit dierent
om that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:

1. This equipment may not cause harmful interference.

2. This equipment must accept any interference received,
including interference that may cause undesired operation.

Modications not authorized by the manufacturer may void
the user’s authority to operate this device. This equipment
complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This transmier must not be

co-located or operating in conjunction with any other antenna
or transmier.

Warranty information

All dreamGEAR/i.Sound products come with a limited warranty
and have been subjected to a thorough series of tests to
ensure the highest level of dependability and compatibility. It
is unlikely that you will experience any problem, but if a defect
should become apparent during the use of this product,
dreamGEAR warrants to the original consumer purchaser that
this product will be ee om defects in material and
workmanship for a period of 120 days om the date of your
original purchase. If a defect covered by this warranty occurs,
dreamGEAR, at its option, will repair or replace the product
purchased at no charge or refund the original purchase price. If
a replacement is necessary and your product is no longer
available, a comparable product may be substituted at the sole
discretion of dreamGEAR.

This warranty does not cover normal wear and tear, abusive
use or misuse, modication, tampering or by any other cause
not related to either materials or workmanship. This warranty
does not apply to products used for any industrial,
professional or commercial purposes.

Service information

For service on any defective product under the 120-day warranty
policy, please contact Consumer Support to obtain a Return
Authorization Number. dreamGEAR reserves the right to require
the return of the defective product and proof of purchase.
NOTE: dreamGEAR will not process any defective claims without
a Return Authorization Number.