DreamGEAR DGPS4-6402 User Manual

User Guide

Dual Charge Dock

ENGLISH

HOW TO USE THE DUAL CHARGE DOCK

1. Insert the Micro-USB end of the AC adapter into the back of the Dual
Charge Dock.

2. Plug the other end of the AC adapter into a powered wall outlet.
NOTE: When powered on, the LEDs on the dock will be blue.

3. To charge, place your DualShock® 4 controller upside down on one of the
Micro-USB charging plugs.

4. To charge another controller, place it onto the other Micro-USB charging plug.

5. When charging, the LED will turn red. When fully charged, the LED will
turn blue.

NOTE: Each controller dock has its own LED and will light up red or blue accordingly.
NOTE: When the controller is fully charged, remove the controller from the Dual

Charge Dock.

FCC INFORMATION

This equipment has been tested and found to comply with the limits for a Class
B Digital Device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a

PACKAGE CONTENTS

• Dual Charge Dock

• AC Adapter

• User Guide

• Warranty/Registration Card

residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:

• Reorient or relocate the receiving antenna.

• Increase the distance between the equipment and receiver.

• Connect the equipment to an outlet on a circuit different from that to which
the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:

1. This equipment may not cause harmful interference.

2. This equipment must accept any interference received, including interference
that may cause undesired operation.

Modifications not authorized by the manufacturer may void the user’s authority
to operate this device. This equipment complies with FCC RF radiation exposure
limits set forth for an uncontrolled environment. This transmitter must not be
co-located or operating in conjunction with any other antenna or transmitter.