i n s t r u c t i o n m a n u a l
committed to delivering quality and innovative products for you and your family
Congratulations on your purchase of a Dreamer Design Jogging Stroller.
verve
spt
™
d r e a m e r
D E S I G N
Before we walk you through the simple assembly of your new stroller we would like you to take
a moment and read through the entire instruction booklet to insure the process goes as
smoothly as possible. After you have finished assembling your stroller keep this booklet for
future reference.
Please note that if you don't follow the instructions you or your child could be seriously injured.
Correct assembly of the stroller is vital and outside of the manufacturer's and distributor's
liability.
i n t r o d u c t i o n
Don't throw your box away! It's good to keep it around so you have it if you need to ship or
transport your stroller in the future.
Check to make sure you have all the parts and necessary items needed to assemble the stroller.
If you don't have something that is pictured please call our customer service line at
800.278.9626.
i n t r o d u c t i o n
watch fingers when folding - folding
mechanism could be a pinching hazard
Turn the stroller over so the foot plate is down.
Lift the stroller by the handle until it clicks.
a s s e m b l y
sun canopy
height adjustable
handle
front quick
release wheel
fork tips
thumb tab
harness
pockets
basket
canopy window
water bottle
holders
wheel release
latch
hand brak
e
foot brak
e
trigger
rear wheel
foam protector
To put the rear wheels on, push the wheel
axle into the stroller frame.
Remove and discard the foam protectors on
the wheel axles.
be sure to discard the plastic bags from the wheels -
they are a suffocation hazard for children
check to make sure the wheels are
secure before each use
a s s e m b l y
Tip the stroller back so it is resting on its
handle and rear wheels to put the front
wheel on.
Remove the fork tip protectors.
Make sure the brake release lever is
pointed out, away from the stroller
.
lever pointed out
Starting at the bottom of the brake pads,
push the wheel up and in between the
brake pads.
The quick release lever should be straight
out. While holding the lever, tighten the
thumb nut until it is barely snug. The axle
should not move side to side.
Rotate the tire upwards and find the flat
sides on the round axle and slide all the
way to the back of the forks, on BOTH
a s s e m b l y
Push the quick release lever down so it
is flush with the frame. Give the wheel a
tug to make sure it is secure.
Be sure to close the brake calipers by
pushing the lever forward all the way.
flat side
brake pads
thumb nut
quick release lever
check to make sure the wheel is
secure before each use
lever forward
check to make sure the brake caliper
is locked before each use
Loading...