i n s t r u c t i o n m a n u a l
committed to delivering quality and innovative products for you and your family
Congratulations on your purchase of a Dreamer Design Jogging Stroller.
slingshot rps
™
rebound gst
™
d r e a m e r
D E S I G N
These instructions are for both our Rebound GST™ and Slingshot RPS ™ models. Before we
walk you through the simple assembly of your new stroller we would like you to take a moment
and read through the entire instruction booklet to insure the process goes as smoothly as
possible. After you have finished assembling your stroller keep this booklet for future
reference.
Please note that if you don't follow the instructions you or your child could be seriously injured.
Correct assembly of the stroller is vital and outside of the manufacturer's and distributor's
liability.
i n t r o d u c t i o n
Don't throw your box away! It's good to keep it around so you have it if you need to ship or
transport your stroller in the future.
Check to make sure you have all the parts and necessary items needed to assemble the stroller.
If you don't have something that is pictured please call our customer service line at
800.278.9626.
i n t r o d u c t i o n
watch fingers when folding - folding
mechanism could be a pinching hazard
Turn the stroller over so the foot plate is down.
Lift the stroller by the handle until it clicks.
a s s e m b l y
sun canopy
All Weather Cover
Bike Pump
(not pictured)
foot plate
height adjustable
handle
front quick
release wheel
fork tips
thumb tabs
harness
pockets
suspension
Rebound GST™ model only
basket
canopy window
water bottle
holders
hand brake
foot brake
rear wheel
push button
foam protector
push button
Make sure the foot brake is in the
unlocked, up, position.
To put the rear wheels on, push the button on
the wheel while pushing the wheel axle into
the stroller frame.
Remove and discard the foam protectors on
the wheel axles.
be sure to discard the plastic bags from the wheels -
they are a suffocation hazard for children
check to make sure the wheels are
secure before each use
a s s e m b l y
Tip the stroller back so it is resting on its
handle and rear wheels to put the front
wheel on.
Remove the fork tip protectors.
Make sure the brake release lever is
pointed out, away from the stroller
.
lever pointed out
Starting at the bottom of the brake pads,
push the wheel up and in between the
brake pads.
The quick release lever should be straight
out. While holding the lever, tighten the
thumb nut until it is barely snug. The axle
should not move side to side.
Rotate the tire upwards and find the flat
sides on the round axle and slide all the
way to the back of the forks, on BOTH
a s s e m b l y
Push the quick release lever down so it
is flush with the frame. Give the wheel a
tug to make sure it is secure.
Be sure to close the brake calipers by
pushing the lever forward all the way.
flat side
brake pads
thumb nut
quick release lever
check to make sure the wheel is
secure before each use
lever forward
check to make sure the brake caliper
is locked before each use
Loading...