Draw-Tite 6002 User Manual

INSTALLATION INSTRUCTION

GOOSENECK TRAILER HITCH

6002

WARNING!

DO NOT EXCEED THE MANUFACTURERS GVWR FOR YOUR VEHICLE.

1. Place base rails across truck bed. Place hitch on base rails to establish spread between rails and install base rail mounting kit 30095 or 30035 per kit instructions. Drill holes and add additional bolts (supplied with the gooseneck ball mount) at center holes in base rails using the hole closest to the truck bed channel.

2. Install pull pins and lock in place with spring cotter pins.

3. When safety chains are used, place chain link in slot and install additional pull pins (not furnished) and lock in place with spring cotter pins (not furnished). Safety chain kit 50223 can be used.

Block rear of trailer when loading and

unloading trailer to prevent negative trailer

tongue load when using this product.

Note!

For Installation Assistance or Technical Help, Call 1-888-521-0510

SUPPLEMENT TO 30095N

Insert ½” carriage bolt (29) into the hole. Install ½” serrated washer (31), ½” lock washer (32) and ½”

INSTALL BOLT IN EITHER POSITION. WHICHEVER IS CLOSEST TO UNDER BED SUPPORT. RAIL MAY BE

TURNED TO CHANGE HOLE LOCATION FROM FRONT

TO BACK.

SPACER (30)

SERRATED WASHER (31)

LOCK WASHER (32)

½” HEX NUT (33)

ADDITIONAL MOUNTING INSTRUCTIONS:

Install base rails as instructed in respective instructions. The instruction below is for the addition of the 2 center bolts for applications using 30095.

½” CARRIAGE BOLT (29)

1. Place base rails in accordance with base rail mounting instructions.

2. BEFORE DRILLING ANY HOLES, CHECK FOR CLEARANCE AROUND THE GAS TANK.

3. Using the center hole in the base rail as a guide, drill a ½” hole through the truck bed.

nut (33).

5. Insert spacer (30) between the truck bed and the base rail. It will go in between at the corrugation of the bed. To keep bed from crushing when the bolt is tightened.

6. Repeat for the other base rail.

7. Torque the ½” nuts to 75 ft/lbs.

For Installation Assistance or Technical Help, Call 1-888-521-0510

FIVE YEAR LIMITED WARRANTY

Cequent Performance Products Inc. warrants its Gooseneck Ball Assembly from date of purchase against defects in material and workmanship under normal use and service, ordinary wear and tear excepted, for 5 years of ownership to the original consumer purchaser when a Cequent Performance Products Inc. mounting kit is used.

Cequent Performance Products Inc. will replace free of charge any part which proves defective in material or workmanship when presented to any Cequent Performance Products Inc. dealer or Cequent Performance Products Inc. warehouse, or when returned to the factory, TRANSPORTATION CHARGES PREPAID, at the address below. THIS WARRANTY IS LIMITED TO DEFECTIVE PARTS REPLACEMENT ONLY. LABOR CHARGES AND/OR DAMAGE INCURRED IN INSTALLATION OR REPLACEMENT AS WELL AS INCIDENTAL AND CONSEQUENTIAL DAMAGES CONNECTED THEREWITH ARE EXCLUDED.

Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you.

Any damage to the Gooseneck Ball Assembly as a result of misuse, abuse, neglect, accident, improper installation, or any use in violation of the instruction furnished by us WILL VOID THE WARRANTY. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. In the event of a problem with warranty service or performance, you may be able to go to a small claims court, a state court, or a federal district court.

Cequent Performance Products, Inc. 47912 Halyard Dr., #100 Plymouth, MI 48170 USA