Draw-Tite 59904 User Manual
Product Name:
Kit Contents:
Adapter Bike for Basket
Product Code:
59904
Please read all instructions carefully before assembly, installation and/or use of this product.
WARNING
DO NOT EXCEED the lowest of vehicle manufacturer’s or hitch mfg’s maximum tongue weight rating, or
cargo basket weight limit .
Before Transport You MUST: Securely fasten all loads to cargo basket. Make sure all bolts, straps, knobs, and
clamps are firmly attached and secure before every trip.
Distribute your cargo evenly inside the cargo basket.
Check the security of load, bolts, straps, knobs, and clamps at fuel and rest stops.
IMPORTANT NOTES:
• Bicycle must be equipped with quick release front
wheel clamp.
• Designed for use with Fork Drop Outs that are
100mm wide, inside to inside.
• Bicycle forks must be equipped with Safety Tabs.
100mm (3-15/16”)
Safety Tabs
Fork
Drop Outs
Designed for Forks
With Safety Tabs
ITEM NO. QTY. PART NO. DESCRIPTION
a 1 122533 Adapter Assembly
b 1 116846 L-Wrench
c 2 05084-020 M6-1.0 x 20mm Security Bolt
d 2 122530 M6-1.0 Locknut
e 1 122528 Top Strap Bracket
f 1 122529 Bottom Strap Bracket
g 1 122522 Skewer Clamp Assembly
h 1 122518 Tire Strap
c) M6 x 20mm
Security bolt
a) Adapter Assembly
d) M6 Lock Nut
b) L-Wrench f) Bottom Strap Bracket
e) Top Strap Bracket
g) Skewer Clamp Assembly
h) Tire Strap
Cequent Performance Products
Plymouth, MI 48170
Technical Service: (888) 521-0510
Page 1 of 4
59904N Rev A 10-12-11
Printed in XXXXX
Product Name:
Adapter Bike for Basket
Please read all instructions carefully before assembly, installation and/or use of this product.
1
Cargo Basket Rail
Adapter
Assembly
Product Code:
59904
Assembly Instructions:
1. To attach Adapter Assembly to cargo basket,
use the L-Wrench supplied to loosen the bolt
and open the clamp jaw. Place Adapter
Assembly onto basket side rail tube and
tighten using L-Wrench supplied.
2. Note, the position and angle of Adapter
Assembly will vary depending on the number
of bicycles you are transporting.
Clamp Adapter to basket rail
2
3a
Conical Spring
Orientation
3. To attach Rear Tire Bracket & Strap
Assembly to cargo basket, measure the
distance between front wheel axle to rear
wheel axle.
4. Place the strap brackets & nylon strap
around expanded metal floor and install the
M6 x 20mm long security bolts as shown.
Note: Align hole in strap with post in top
strap bracket.
Bike Forks
Bicycle Loading:
5. To attach bike to Adapter Assembly,
unscrew Skewer Clamp to maximum width.
6. Remove front wheel from bike and place
bike fork drop-outs down onto fork mount as
shown.
7. With Skewer Clamp Lever open, tighten until
Clamp Lever closes with firm resistance and
fully closes as shown in step 3a & 3b.
Cequent Performance Products
Plymouth, MI 48170
Technical Service: (888) 521-0510
Page 2 of 4
59904N Rev A 10-12-11
Printed in XXXXX
Loading...