Draw-Tite 58386 User Manual

2009 & UP-DODGE RAM 1500, INCLUDING CREWCAB ( USE WITH 30035 KIT )

CAUTION!

Read pages 2-3 of 30035 instructions before starting installation. Failure to do so could result in significant vehicle damage!

IMPORTANT NOTES FOR THIS INSTALLATION:

1. Tube spacer and 4 1/2” carriage bolt used to attach through forward Bed Sill (Row 2).

2. **Rib neck bolts will need to be pulled through access holes in frame with supplied pull wire (see below).

3. Do not drill thru both walls

ROW 1

of frame. Drill only thru wall
of frame to which bracket is
mounted.

Each base rail must
have a bolt in either
of the marked center
holes. Check for
obstructions before
drilling.

Front of

Vehicle

ROW 2

Drill through
Bed Sill with

17/32” drill.

Open up hole
through truck
bed only with

1” dia. drill.

Drop tube
spacer through
hole in truck
bed to avoid
crushing Bed
Sill when
torquing 4-1/2”
carriage bolt.

ROW 4

ROW 3

28 5/8” Short Box

(Crewcab models (less than

6’ bed) require a Sidewinder

Pinbox Coupler)

30 1/4” Long Box

Measure from Rear Edge
of truck bed to rear edge of
base rail.

Rear Edge

of Truck

Bed

King Pin Center
approx. 1-1/2” forward
of axle center.

Use provided(30035 kit) tube
spacers and 4-1/2” carriage bolts
to attach through Bed Sill

Bed Sill

Forward Side Bracket

1/4 2

*

1/4 2

Axle Center

Bed Sill

* Optional weld

pattern

1/4 2
1/4 2

*

CAUTION!

Check for obstructions before drilling. Failure to do so could result in damaged fuel or brake lines, structural members, etc.

TOWING PRODUCTS does its best to communicate tow vehicle manufacturer changes; however, it is ultimately the responsibility of

the installer to prevent damage due to installation.

z 2008, 2009 , 2013 Cequent Performance

Sheet 1 of 1 58386N 10/24/13 Rev. D