Preparing Corner
Floor Cabinet
To make assembly easier we recommend having
two persons aid one another in assembly.
Item Description
Quan-
tity
1 Left Back Panel 1
2 Right Back Panel 1
3 Left Side Panel 1
4 Right Side Panel 1
5 Door 1
6 Bottom Panel 1
7 Connecting Beam 1
8 Front Kick Panel 1
9 Side Kick Panel 2
10 Shelf Panel 1
Stock No.
33199
1
2
7
3
10
11
5
4
8
6
11 Foot Holder 3
12 Front Foot Holder 2
13 Leg Leveller 5
14 M8 x 16mm bolt 20
15 M6 x 16mm bolt 12
CABINET CONNECTION
Connect the side panels of two cabinets
with (4) bolt M6 x 16mm and nut M6,
and tighten with phillips screwdriver
(not included).
Note: remove the drawers and open the
doors before cabinet connection.
14
13
12
15
9
16
STEP 2:
Attach left and
right back panels
to left and right
side panels
(item 3 and 4)
by engaging the holes
on the
side panels with the
corresponding hooks
on the
back panels.
STEP 1:
Place the left back panel
(item 1) and right back panel
(item 2) together on a level
surface. Attach right back panel
to left back panel by engaging
the holes on the left back panels
with the corresponding hooks on
right back panel.
STEP 5:
Use packaging material to protect the unit. Attach the leg leveller
(item 13) to foot holder (item 11 and 12). Insert bolt
M8 x 16mm (item 14) through the foot holder into the cabinet.
STEP 6:
Attach the front and side
kick panel (item 8 and 9)
to foot holder with bolt
M6 x 16mm (item 15).
STEP 7:
Obliquely place the shelf panel (item 10) in the cabinet from top,
secure the shlef panel at desired height by carefully inserting
the shelf edges into the anges on left side panel and right back
panel. Make sure the shelf is level.
STEP 4:
Insert the bottom panel (item
6) into the side and back
panels.
drapertools.com
STEP 3:
Attach connecting beam
(item 7) to left and right side
panels, algin the tabs on right
hand side of the connecting
beam with the holes on right
side panel, slide the connecting
beam together with tabs and
holes fully engaged. Repeat the
step above to complete another
side assembly.
STEP 8:
Place the at washer (item 16) into the hinge pin, algin the hinge
pin on the bottom of the door with the hole on bottom panel,
slowly and carefully insert the hinge pin into the hole. Algin the
hinge pin on the top of the door with the hole on connecting
beam, slowly and carefully insert the hinge pin into the hole.
Draper Tools Limited, Hursley Road, Chandler’s Ford, Eastleigh, Hampshire. SO53 1YF UK.
Loading...