Draper Tools 14172 Instructions

SINGLE CYLINDER

FOOT PUMP

14172 - 4430 INSTRUCTIONS

• Use foot pump on a flat surface to prevent excessive twisting of frame.

• Unscrew tyre valve cap, push connector firmly onto the tyre valve and
then secure by depressing the thumb lock

• For efficient pumping action, place foot centrally on the foot plate and
use full strokes on the pump.

• Ensure that the air hose is neither stretched nor kinked during pumping.

• After inflation, lift the thumb lock and release the connector quickly
from the tyre valve.

• Replace tyre valve cap.

• Always store with frame clip applied. Store carefully, particularly if
stored in the car.

• Every 3 months lubricate pivot points with light oil and apply a few
drops through the holes in the bottom of the cylinder.
Several pumping strokes will be required to distribute the
oil.

Note: The gauge on this footpump
is intended as a
guide only.

CARS, MOTORCYCLES AND
BICYCLES WITH SCHRADER
TYPE VALVES

Push connector firmly onto the
tyre valve & then secure by
depressing the thumb lock on
the connector-

THUMB LOCK

CONNECTOR

(A).

INFLATABLES AND
SPORTS BALLS

For inflatables, use the plastic
adaptor; simply press connector onto top of
plastic adaptor and secure by depressing the
thumb lock onto the connector-

For sports balls, use the
needle valve.

NEEDLE VALVE

BICYCLES

PLASTIC ADAPTOR

For bicycles with Woods

valves, screw adaptor firmly

onto the Woods valve,

then push connector onto

adaptor and secure by

depressing the thumb

lock onto the connector-

(B).

(B)

(C).

(A)

(C)

Helpline: [phone] Sales Desk: [phone] General Enquiries: [phone]

Draper Tools Limited, Hursley Road, Chandler’s Ford, Eastleigh, Hampshire. SO53 1YF UK

internet: drapertools.com email: [e-mail]

SQCH0121