Page 1
■ STOCK No.57491 ■ PART No.MS560/3
•INSTRUCTIONS•
06/99
IMPORTANT: PLEASE READ THESE INSTRUCTIONS
THOROUGHLY BEFORE USE.
UNDERSTANDING HOW THIS MACHINE WORKS AND SETTING IT
CORRECTLY IS FUNDAMENTAL TO OBTAINING
A SATISFACTORY RESULT.
MITRE SAW
Page 2
MITRE SAW TECHNICAL DATA
COMPONENT PARTS
1. Saw table.
2. Two plastic feet with screw
holes for bench mounting.
3. Saw frame assembly.
4. Two cut depth stops.
5. Guide rods.
6. Washer for pivot arm
(see STEP 1).
7. Pivot arm.
8. Angle indicator.
9. Four grub screws.
10. Hexagon key.
11. Rubber feet.
12. Material vice clamp.
13. Adjustable length stops.
✖✌
✗✌
✙✌
✘✌
✕✖✌
✕✔✌
Specification:
Max. cutting width clamped at 45º.............100mm
Max. cutting width clamped at 90º.............160mm
Max. cutting width unclamped at 90º.........110mm
Max. cutting height.....................................110mm
Blade lengths.............................................560mm
Blade widths 18, 24 TPI...............................40mm
Bow saw ...............................20mm
Table size ..................................76x348mm (WxL)
Max. reach of adjustable length stop....385mm
✕✌
✕✕✌
✢✌
✕✗✌
✛✌
✚✌
✜✌
Page 3
PRE-SET ANGLES
ASSEMBLY OF MITRE SAW
ASSEMBLY OF ACCESSORIES
The material vice clamp ✕✖✌ can be mounted on the left or right hand side of the saw
table front for holding workpieces securely.
The adjustable length stop ✕✗✌ can be mounted at either end of the saw table and set
for the required length of cut.
Replacement blades are available from your local Draper stockist;
18TPI - Stock No.57810, 24TPI - Stock No.57811, Bow Saw Blade - Stock No.57812.
STEP 1. STEP 2. STEP 3.
STEP 4. STEP 5. STEP 6.
Tur n
5-1/8 turns
✚✌
When fitting blade, always
ensure teeth point forwards.
Page 4
To get the best from your saw, you must make sure it is correctly set, ensuring the
following points are correct:
(a) The saw blade is tensioned sufficiently to avoid ‘whip’ which will cause the blade to
deviate from a true cut.
(b) The blade is ‘in line’ and central to the frame.
(c) Blade tension is always released after use.
(d) The workpiece is square and true to the base casting.
(e) The correct type of blade is used.
SAFETY FIRST TO AVOID INJURY: Do not remove the blade guard whilst fitting the bow
saw blade to the frame. Refit the blade guard when work is complete and when
removing the blade from the frame.
After assembly has been carefully carried out, always test your mitre saw and the
angles with some scrap timber, to ensure the machine is assembled correctly and
cutting true.
DRAPER TOOLS LIMITED,
Hursley Road, Chandler's Ford,
Eastleigh, Hants. SO53 1YF. England.
Tel: (01703) 266355.
Fax: (01703) 260784.
©Published by Draper Tools Ltd.
No part of this publication may be reproduced,
stored in a retrieval system or transmitted in
any form or by any means, electronic, mechanical
photocopying, recording or otherwise without prior
permission in writing from Draper Tools Ltd.
SAW SETTING
IMPORTANT WARNING
Loading...