Safety Helmet
Stock Nos. 51138 Part Nos.SH1. Yellow
51139 White
51140 Blue
65705 Orange
65706 Black
INSTRUCTIONS
1. SPECIFICATION AND MARKINGS
®
EN397:2012+A1
EN 397:2012+A1 The European Standard Number for Industrial Safety Helmets and
its year of publication
53-63 cm The size range of the helmet, head circumference.
-20ºC/-30ºC The helmet will provide some protection when worn in an
environment at or above these temperatures.
440 Vac The helmet will protect the user against short term, accidental
contact with live electrical conductors up to a voltage of 440 Vac
(Volts a.c ).
LD The helmet will provide some protection from lateral compressive
loads.
2. FITTING AND ADJUSTMENT
For adequate protection this helmet must fit or be adjusted to the size of the users
head.
The helmet must be worn with the peak facing forward.
To alter the fit, adjust the harness at the rear of the helmet and ensure a
comfortable fit is made around the crown of the head.
When not in use or during transportation, this helmet should be stored in a
container such that it is out of direct sunlight, away from chemicals and abrasive
substances and cannot be damaged by physical contact with hard surfaces/items.
DRAPER TOOLS LTD, HURSLEY ROAD, CHANDLER'S FORD, EASTLEIGH, HANTS. SO53 1YF. U.K. www.drapertools.com e-mail: sales@drapertools.com
PSKC 110314
3. USAGE
The helmet is made to absorb the energy of an impact by partial destruction or
damage to the shell or harness and even though such damage may not be readily
apparent, any helmet subjected to severe impact should be replaced.
The attention of users is also drawn to the danger of modifying or removing any of
the original component parts of the helmet, other than as recommended by the
helmet manufacturer.
Helmets should not be adapted for the purpose of fitting attachments in any way
not recommended by the helmet manufacturer.
Accessories and/or replacement harnesses, chin straps, ear defenders, visors and
helmet mounted lamps are available with fitting instructions from JSP.
Do not apply paint, solvents, adhesives or self-adhesive labels, except in accordance
with the instructions from the helmet manufacturer.
4. INSPECTION AND CARE OF THE HELMET
The helmet is a complete system consisting of shell and harness.
The helmet's useful life is affected by many factors including the cold, heat,
chemicals, sunlight and misuse.
The helmet should be examined daily for obvious signs of cracking, brittleness or
damage to either helmet or harness.
The date of manufacture is moulded into the peak of this helmet.
While the helmet is free from defects it is suitable for its intended purpose.
Under normal circumstances the helmet has a maximum life of 5yrs from date of
manufacture.
Under no circumstances must a component other than a JSP component be used on
a helmet.
The helmet may be cleaned with the use of soap and warm water and dried with a
soft cloth.
The helmet should not be cleaned with abrasive substances or solvents and must
not be stored in direct sunlight or in contact with any solvents.
DRAPER TOOLS LTD, HURSLEY ROAD, CHANDLER'S FORD, EASTLEIGH, HANTS. SO53 1YF. U.K. www.drapertools.com e-mail:
PSKC 110314
Loading...