Do not overload the following wall outlets, extension cords or integral convenience receptacles as this
can result in a risk of fire or electrical shock
Never allow liquids, spray or other materials to come into contact with the inside of the STB.
Unplug the STB from the wall outlet before cleaning.
Use a soft cloth and a mild solution of washing-up liquid to clean the exterior of the STB.
Allow clear apace around the STB for sufficient ventilation.
Do not use the STB where it is exposed to direct sunlight or near a heater.
Never stack other electronic equipment on top of the STB.
Locate the STB indoor place properly to prevent lightening, raining and direct sunlight.
Do not use any attachment that are not recommended as these may cause hazards or damage the
equipment.
Do not connect or modify cables where the STB is plugged in.
The antenna signal cable must be earthed to the system earth
Do not cover the STB or place it on a unit that emits heat.
1
FRONT PANEL
1. Card slot (spare)
2. EXIT: return to the program-watching status
3. MENU: Menu entry
4. OK: menu confirmation/ channel list
5. Remote receiver
LED display window
REAR PANEL
1. Power switch
2. Loop output terminal
3. Antenna signal input terminal
4. Serial data interface
5. S/PDIF output terminal
6. Standby switch
7. Volume decrease/ left button
8. Channel increase/ up button
9. Volume increase/ right button
10. Channel decrease/ down button
6. S-VIDEO terminal
7. Video signal output terminal
8. Audio signal output terminal
9. VCR scart
10. TV scart
2
REMOTE CONTROLLER KEYS
Advice you operate each function of the STB using the button on the remote controller. Please read this
section to help advance your understanding of the function of the STB
To mute the audio output
To instruct the unit to enter standby mode
Non-menu: To show the favorite type
Non-menu: to switch the STB TV Scart signal
source from the STB or the VCR
Menu mode: to select or adjust the parameter
Non-menu: volume decrease/ increase
Menu mode: to move cursor up/down
Non-menu: to turn over the channel forward or
backward
To return to the last grade menu interface
To show the menu instruction bar
Menu: to fill the parameter value; non-menu: to choose the channel number
Non-menu: to switch whether the caption appear or conceal
Non-menu: to show the present channel’s related information
Non-menu: to shift the program from the present channel to the last one
Non-menu: to switch the scene state from active to still
3
PRECAUTIONS ABOUT BATTERIES
Improper use of batteries may cause corrosion or fluid leakage. Please observe the following
instructions for the safe use of batteries
1. Do not mistake the polarities of batteries
2. Never leave dead batteries in the remote control
3. Remove batteries from the remote controller it is not going to be used for a certain time
4. Do not attempt to disassemble, short-circuit, heat, recharge or throw the batteries into the
fire source
5. Do not use new batteries and old one together, or which is different type
6. Wipe away any electrolyte fluid inside the remote controller, and insert new batteries
Non-menu: to switch the output audio language category
Non-menu: to switch the watching state from TV to Radio
Non-menu mode: to show the stored channel list; menu mode: to confirm the operation
4
Loading...
+ 12 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.