Dp P36 User Manual

P36

Tail cap (A)

Battery : 3 x AAA - Alkaline or NiMH

USER MANUAL

Unscrew tail cap
anti-clockwise to
change batteries

Fitting batteries :

1. Make sure flashlight is off and unscrew the tail cap (A).

2. Remove old batteries and install new batteries in the correct polarity. Insert new batteries according

to the polarity indications (+) and (-) marked on the battery holder. Care to install the batteries as

described as failure to do this may cause damage to the flashlight.

3. Screw the tail cap back into place. The torch is now ready for use.

Operation :

Full pressing (B)

Half press (B)

Repeated full press (B)

Main switch (B)

Focusable

Light on (100%) ---> Light off

Momentary on

Light on (100%) ---> Light on (50%) ---> Light on (8%) --->
Strobe ---> Light off (the cycle repeats)

Head

Features :

- Light modes : 3 – High / medium / low + strobe and momentary-on

- Focus : Easy one handed instant focusing

- Body durable aircraft grade aluminum with hard wearing anodized protective coating

- Polarity protection and PWM regulation for accurate light output

- Ant-roll

Specifications :

Lumens : 300lm / 150lm / 25lm

Candela : 3720cd

Beam distance : 120m

Runtime : 2h / 8h 45min / 27h

Waterproof : IPX4

Impact resistant : 1.5m

Battery : 3 x AAA – Alkaline or NiMH

LED : Cree XP-G2

Weighs : 79g without batteries

Dimensions : 116.5 x 27mm