Page 1
Top-Mount / Under-Mount Sinks
INSTALLATION GUIDE
Installation Instructions for Top-Mount / Under-Mount Sinks
Please carefully read complete instructions before beginning installation.
Note: It is recommended that all countertops be cut by an approved or certified installer and that the sinks
be installed by the installer whenever possible. The countertop/sink unit ideally should be installed as one
on the jobsite.
TOOLS AND MATERIALS YOU WILL NEED:
Eye Protection (safety glasses/goggles)
Strongly Recommended
Ear Protection
Strongly Recommended
Drill and Drill bit Pencil (NOT a permanent marker)
Saber Saw Appropriate Sealant for Countertop Material
Wood Braces Rags
Be sure to use proper tools and always wear personal safety devices for your protection.
Phillips Head Screwdriver
Tape Measure
Step 1
Place the template on the counter top in desired position and trace completely outside rim (for top-mount
installation) or inside rim (for under-mount installation) using pencil.
Step 2
Remove template and drill hole at the inside corner of the cutout line.
Page 1 of 4
Page 2
Top-Mount / Under-Mount Sinks
INSTALLATION GUIDE
Step 3
Using a saber saw, start cutting from the drilled hole along the cutout line. Support cutout until the cut is
completed.
Step 4
Set the sink temporarily into the cutout opening to verify fit (Left is top-mount installation and right is
under-mount installation). The sink rim must set uniformly on the counter top. If the sink does not fit, enlarge the
cutout opening carefully
Step 5
Install faucets and other accessories such as a side spray or soap/lotion dispenser onto the sink.
Page 2 of 4
Page 3
Top-Mount / Under-Mount Sinks
INSTALLATION GUIDE
Step 6
Attach and space the clips around the underside of the sink. Number of clips varies between models. Be sure to
arrange spacing evenly around the sink. Apply sealant around the sink rim to serve as a watertight seal.
Step 7
Lower the sink into the hole carefully and tighten the clips evenly with the screwdriver.
(Left is top-mount installation and right is under-mount installation)
Step 8
Wipe away the excess sealant and allow to dry. Make the drain connections. Run water through the sink and check
for leaks.
Page 3 of 4
Page 4
Top-Mount / Under-Mount Sinks
INSTALLATION GUIDE
Care and Cleaning
Cleaning
Clean regularly with a mild detergent solution and/or clean water applied with a soft cloth or
sponge. Rub gently.
Rinse and wipe the sink dry after every use to prevent water spotting &mineral deposits in
severe hard water conditions.
Deep clean once a week with a recommended cleanser (be sure to rub in the direction of the
finish lines) and a soft cloth or sponge rather than aggressively cleaning.
Please note chlorides are found in most all soap, detergents, blenches and cleansers. Chlorides can
be harsh on stainless steel. Rinse your sink thoroughly after each use to remove any chloride
residue.
Scratches
Scratches are inevitable during your usage over time. To treat, use a nylon pad with an iron free
abrasive polishing compound. Follow the original polish lines to blend out the scratch in a small
area. Be cautions not to overdo the process, as cleaning too aggressively could result in a bright
spot.
Some Don'ts:
Do not use any abrasive cleaners such as steel wool or scrub pads.
Don't leave wet sponges, cloths, cleaning pad, rubber mats or dishpans in the sink. This could
lead to surface rust or possible pitting.
Do not leave standing solutions of chlorine bleach and water in the sink for extended periods of
time. Always rinse the sink after using such solutions.
Do not allow liquid soap or other cleansers to dry on the surface of the sink.
Page 4 of 4
Loading...