Dowco Guardian Storeaway Motorcycle User Manual

Installation

Read instructions before using.

Unfold cover. Locate ”FRONT” tag, indicating which
part of the cover goes to the front of the motorcycle.

Starting in the front wheel area, pull down over the
windshield over the centerline of the wheel.

Working toward the rear of the motorcycle, slide the
cover down the sides, avoiding “snag” points. The
cover should be long enough to allow the hem to
fully lay below the centerline of the rear wheel. Care
should also be taken to avoid placing the material
against hot engine components, as burning or melt­ing may occur.

Caution: Mirrors, muffler ends, shifters, brakes and
foot pegs are common wear points. Do not allow
fabric to “snag” around them. Antennas are capable
of puncturing the cover – use extreme care.

Important

Wait for the motorcycle to cool-down before
installing the cover. This will greatly increase the life
of your cover.

Care and Cleaning

Your cover requires very little maintenance. Normal
dirt and grime should be brushed off with a soft terry
cloth or removed with warm water and a mild
detergent using a sponge or terry cloth. The cover
should be thoroughly dried before using.

Caution: Do not place in washing machine and do
not wring or twist the cover to remove moisture.

Important

Failure to comply with the above directions may
reduce the life of your cover. If you have any
questions or comments, please contact either your
dealer or DOWCO Inc.

Congratulations on your purchase of a DOWCO Inc. motorcycle cover. The GUARDIAN

®

STOREAWAY

™

cover is manufactured from 100% polypropylene and is intended for indoor storage only. The following
information should be used to ensure maximum longevity.

Note: All GUARDIAN®STOREAWAY™covers are available in two sizes. It is very important that you have
the correct one for your application. If you are uncertain that your GUARDIAN

®

STOREAWAY™cover is

correct, please contact your dealer or DOWCO Inc. to verify your fit before attempting first-time use.

Note: This cover is not designed for covering your motorcycle while it is outdoors, being

trailered or in the back of a pick-up truck.

INSTRUCTIONS FOR THE INSTALLATION OF

GUARDIAN

®

STOREAWAY™MOTORCYCLE COVER

Form # 00078

Revised 06/04

Printed in China

This cover must be completely removed prior to starting
or operating the vehicle. Failure to do so could result in
serious injury and/or property damage.

4230 Clipper Drive Manitowoc, WI 54220 U.S.A.

Phone: [phone] - Fax: [phone]

Visit our Web Site! - www.dowco-inc.com