Dowco Guardian Custom Bike Motorcycle User Manual

Installation

Read instructions before using.
Unfold cover. Locate “BACK” tag.
Starting in the front wheel area, pull down over the

windshield and “tuck” the elastic hem under the
centerline of the wheel.

Working toward the rear of the motorcycle, slide the
cover down the sides, avoiding “snag” points. The
cover should be long enough to allow the elastic
hem to fully wrap below the centerline of the rear
wheel and have a tight fit along the perimeter. Care
should also be taken to avoid placing the material
against hot engine components, as burning or melt­ing may occur.

Caution: Mirrors, muffler ends, shifters, brakes and
foot pegs are common wear points. Do not allow
fabric to “snag” around them. Antennas are cap able
of puncturing the cover – use extreme care.

Important

Wait for the motorcycle to cool-down before
installing the cover . This will greatly increase the life
of your cover. Grommet patches are provided to
enable you to secure the cover under the
motorcycle.

Care and Cleaning

Your cover requires very little maintenance. Normal
dirt and grime should be brushed off with a soft terry
cloth or removed with warm water and a mild
detergent using a sponge or terry cloth. The cover
should be thoroughly dried before using.

Caution: Do not place in washing machine and do
not wring or twist the cover to remove moisture.

Important

Failure to comply with the above directions may
reduce the life of your cover. If you have any
questions or comments, please contact either your
dealer or DOWCO Inc.

Congratulations on your purchase of a GUARDIAN

®

custom bike indoor cover. Properly cared for, your
cover will last for many years of service. The GUARDIAN®custom bike cover is manufactured from 100%
cotton fabric and is intended for indoor storage only. Your cover also contains an elastic shock cord that is
sewn into the hem. This feature keeps the cover tight around the wheels. The following information should
be used to ensure maximum longevity.

Note: All GUARDIAN

®

custom bike covers are sized to fit specific motorcycles. It is very important that you
have the correct one for your application. If you are uncertain that your GUARDIAN®custom bike cover is
correct, please contact your dealer or DOWCO Inc. to verify your fit before attempting first-time use.

Note: This cover is not designed for covering your motorcycle while it is outdoors, being

trailered or in the back of a pick-up truck.

INSTRUCTIONS FOR THE INSTALLATION OF

GUARDIAN

®

CUSTOM BIKE INDOOR COVER

Form # 00303

01/04

Printed in China

This cover must be completely removed prior to starting
or operating the vehicle. Failure to do so could result in
serious injury and/or property damage.

4230 Clipper Drive Manitowoc, WI 54220 U.S.A.
Phone: [phone] - Fax: [phone]

Visit our Web Site! - www.dowco-inc.com