Dowco Fastrax 50144-00 Installation Instructions Manual
INSTALLATION INSTRUCTIONS
BAG INSTALLATION: 50144-00
FASTRAX BACKROADS TAIL BAG
WARNING
Please read and understand these instructions completely before installation to avoid possible injury to yourself or damage to
the accessory or vehicle. If you are unsure of your ability, seek the help of a qualified mechanic.
Overloading any Tail Bag will result in a high center of gravity which will cause bike to be come top heavy and susceptible to
unexpected tipping, especially on lean-in, while negotiating high speed turns. Maximum allowable load limit is 10 lbs.
Verify that straps do not obstruct exhaust system, turn signals, or tail lamp may result in injury or property damage.
1. Parts List:
This product contains the following components. Before beginning installation confirm there are no missing or damaged components.
Item # Description Qty
1. Tail Bag 1
2. Accessory Bag 1
3. Strap 12” long with (2) Hooks 4
4. Strap 29” long with (2) Hooks 1
5. Strap 20” long with (1) Hook 2
6. Strap 25” long with (1) Hook 2
7. Protective Strap Pads 3
2. Preparation:
Note: This product is supplied with a scratch resistant rubberized bottom layer. Care should be taken to avoid gas
spills and heavy buildup of dust and/or dirt under the bag; this may lead to scratches in the paint finish. Therefore
the following preparation should take place before mounting the luggage.
a. Place motorcycle on a secure, level surface
b. Clean all mounting surfaces before beginning installation.
3. Installation:
Note: This product is supplied with a number of different straps and strap lengths. Below are only a few suggested combinations to
securely mount to a motorcycle. You must choose which mounting system is best for your application.
Mounting Tail Bag Only
a. Place
b. Place and center magnetic unit directly on metal tank (Fig. 1)
c. Position magnetic flaps to conform to tank profile.
d. Insure that bags does not interfere with steering in full le
172 7/14
INSTALLATION INSTRUCTIONS
BAG INSTALLATION: 50144-00
FASTRAX BACKROADS TAIL BAG
Mounting Tail Bag Only
a. Place Tail Bag on tail section of bike with carrying handle facing the rear of the bike. (Fig. 1)
b. Locate both 20” long straps with (1) hook.
c. Secure straps to passenger foot peg or suitable fixed frame member on le and right side of bike. (Fig. 2)
d. Connect straps to front D-ring on bag.
e. Locate 29” long strap with (2) hooks.
f. Install 29” strap around tail section of bike and connect to bag (Fig. 1)
g. Adjust straps to create a snug fit on bike.
h. Insure that bag does not interfere with indicator lights, tail pipe or any moving parts of the
motorcycle. If you encounter interference, readjust bag position using adjustable straps.
Accessory Bag
a. Accessory bag must be filled prior to installation.
b. Center Accessory bag on top of Tail bag with zipper facing down.
c. Connect all Accessory bag straps to D-rings located at the top of the Tail bag.
d. Adjust all straps to securely position bag in desired location.
Fig. 1 Fig. 2
D-RING
PAD
HANDLE
01072 7/14
20” STRAP
Loading...