Page 1
Assembly Instructions
Caution: You must read this before you proceed
CHAIR
Caution: This Chair is NOT a TOY
Keep your child/ children at bay during the assembly process.
Whenever moving/lifting the Chair and to prevent damage to the Chair two adults are
needed to execute these actions.
1 ____
Page 2
Label Picture Description QTY
A Backrest Panel 1
B Right Leg Panel 1
C Left Leg Panel 1
D Seat Panel 1
E Seat Cushion 1
Label Picture Description QTY
① Bolt (M6x75mm) 9
② Bolt (M6x35mm) 9
③
Spring Washer (M6.5x2mm)
13
④ Washer (M6.5x2mm) 13
⑤ Allen Key 1
Hardware
Parts List
2 ____
Page 3
This Chair has multiple parts and may require up to 30 minutes to assemble. To give you an overview of
the Chair parts, the above picture is to help you put the various parts into perspective. Please read
through the instructions below to familiarise yourself with the parts and steps before assembly.
Assembly Preparation
Assembly Steps
Overview
Before Beginning Assembly:
Seat Panel (D)
Backrest Panel (A)
FRONT FACING
Right Leg Panel (B)
Left Leg Panel (C)
Seat Cushion (E)
3 ____
Page 4
Step 1
Place the Left Leg Panel(C) facedown onto a clean, non-marring surface.
Attach the Backrest Panel(A) to Left Leg Panel(C) using Bolts(②) with Allen Key(⑤).
Do not fully tighten the Bolts.
Unpack and place all parts on a clean, non-marring surface.
Step 2
4 ____
Page 5
3.1) Attach Seat Panel(D) to Left Leg Panel(C) using Bolts(②), Spring Washers(③), and Washers(④)
with Allen Key(⑤).
3.2) Attach Seat Panel(D) to Left Leg Panel(C) using Bolts(①), Spring Washers(③), and Washers(④)
with Allen Key(⑤).
Do not fully tighten the Bolts.
Step 3
5 ____
Page 6
Step 4
With assistance from your adult partners, align assembled frame from Step 3 to Right Leg Panel(B).
4.1) Attach Backrest Panel(A) to Right Leg Panel(B) using Bolts(②) with Allen Key(⑤).
4.2) Attach Seat Panel(D) to Right Leg Panel(B) using Bolts(②), Spring Washers(③), and Washers(④)
with Allen Key(⑤).
4.3) Attach Seat Panel(D) to Right Leg Panel(B) using Bolts(①), Spring Washers(③), and Washers(④)
with Allen Key(⑤).
Do not fully tighten the Bolts.
6 ____
Page 7
Place Seat Cushion(E) into the Chair as shown above.
Your Chair is ready for use.
This Chair can only be used on a flat, level surface.
Place the Chair on a LEVEL SURFACE.
Gently and gracefully, sit into to the Chair.
This pressure will help the Chair reach full alignment at all joints.
In a sequential manner, gradually tighten all Bolts until evenly secured.
When tightening the Bolts tighten sequentially.
DO NOT tighten any Bolt fully and then move on towards the next one.
If there are still wobbles, loosen the Bolts and execute this same process.
Step 5
Step 6
7 ____
Page 8
8 ____
Loading...