ASSEMBLY INSTRUCTIONS
Description
: 42" ROUND TABLE WITH SINGLE PEDESTAL
Dimension
: Ф42xH.30”
Cube Size : 44”x44” x4” NW: 37.4 LBS
(Top) GW: 44 LBS
Cube Size : 27.1”x10.2”x8.8” NW: 19.8 LBS
(Pedestal) GW: 23.1 LBS
42" ROUND TABLE WITH SINGLE PEDESTAL
- 1 -
BEFORE ASSEMBLY
Thank you for purchasing this quality product. This product has been designed for easy assembly and constructed for durability.
Please take the time to read and follow the assembly instructions carefully.
Be sure to check all packing material carefully for small parts which may have come loose inside the carton during shipment.
Please separate, identify, and count all parts and metal hardware. Compare with part list to be sure all parts are present.
If hardware is missing or you have difficulty assembling this product, please call for us.
IMPORTANT NOTE:
- Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being
scratched.
- Remove all wrapping material, including staples & packing straps before you start to assemble.
- DO NOT tighten all screws and bolts until completely assembled.
- Keep all hardware parts out of reach of children.
PART LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you
have the following parts:
NO Description Qty Sketch NO Description Qty Sketch
A Top 1
Pedestal
B
column
1
C Leg 4
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you
have all of the following hardware:
NO Description Qty Sketch NO Description Qty Sketch
Flat washer
1
( Φ8.5xΦ19mm)
Hexagon nut
3
(M8x13mm)
8
8
Lock washer
2
( Φ8.5xΦ13mm)
4
Wrench
(M13mm)
8
1
Flat washer
5
( Φ6.5xΦ13mm)
7
(M6x35mm)
Bolt
4
4
6
( Φ6.5xΦ9mm)
Allen key
8
(4mm)
Lock washer
4
1
42" ROUND TABLE WITH SINGLE PEDESTAL
- 2 -
STEP 1
Attach Legs (C) to column (B) by using Nuts (3), and Washers (2) and (1). Tighten with Wrench (4) as
shown below.
STEP 2
Use the Allen key (8) to loosen the bolts, and take off the plate underneath of the table top.
UNSCREW
8
X6
REMOVE
A
42" ROUND TABLE WITH SINGLE PEDESTAL
- 3 -
STEP 4
STEP 3
Put the plates on top of the pedestals (B) with Bolts (7), washers 5) and (6) as shown below.
Tighten with Allen key (8).
Carefully put the pedestal block on the bottom side of the table top, attach the top to plate
with bolts (from step 2) and tighten with the Allen key (8).
8
x6
A
42" ROUND TABLE WITH SINGLE PEDESTAL
- 4 -
Loading...