douxe DXM-003 Installation Instruction

Installation Instruction

English

UNPACKING INSTRUCTIONS

Carefully open the carton, remove contents and lay out on cardboard or other protective
surface to avoid damage.

Check package contents against the Supplied Parts List in the next page to assure that all
components were received undamaged. Do not use damaged or defective parts.

Carefully read all instructions before attempting installation.

IMPORTANT SAFETY INFORMATION

Install and operate this device with care. Please read this instruction before installation, and
carefully follow all instructions contained herein. Use proper safety equipment during installa­tion.

Please call a qualified installation contractor for help if you don't understand these directions or
have any doubts about the safety of the installation.

Do not use this product for any purpose or in any configuration not explicitly specified in this
instruction. We hereby disclaims any and all liability for injury or damage arising from incorrect
assembly, incorrect mounting, or incorrect use of this product.

1

Supplied Parts List

(1)Pole-a

(2)VESA Plate-e1 (2) Nut-f1 (1)M4x6 Bolt-f2(1)VESA Plate-e2

(3)M5x14 Bolt-g (2)M8x12 Bolt-h (1)M10 Bolt-i (1)Support Plate-j

(1)M10 Washer-k (1)Spring Washer-l (1)Grommet Base

(1)“C” Clamp-b (1)“C” Clamp Brace-c

Plate-m

(1)Monitor Arm-d

(1)Wire Clip-n1

(4)Wire Clip-n2 (1)Allen Key-o (1)Wrench-p (12)M4x12

Thumb Bolt-q

(1)Soft Pad-t1

(1)Soft Pad-t2(12)M4x30 Bolt-r (12)M4 Spacer-s

2 3

Step 1

Install the Pole to the Desktop

Option A: Desk Clamp Install

1. Install the “C” Clamp Brace(c) to the Pole
(a) using 3pcs M5x14 Bolts(g), and tighten
using the Allen Key(o),see Figure 1.

2. Attach Soft Pad(t1) to the “C” Clamp Brace
(c), see Figure 2.

3. Install the “C” Clamp(b) to the pole assem­bly according to the thickness of the desk­top. The thickness can be changed to three
positions. Connect it using 2pcs M8x12 Bolts
(h), and tighten using the Allen Key(o). Tight­en the “C” Clamp to the desktop using the
plastic knob, see Figure 3.

Option B: Grommet Base Install

Existing Grommet Hole Installation

If the existing grommet hole comes with a
plastic protector, remove it to ensure a flat
surface before installing the desk mount.

g

b

Plastic Knob

g

a

c

Figure 1

a

m

t1

Figure 2

h

o

Figure 3

1. Install the Grommet Base Plate(m) to the
Pole(a) using 3pcs M5x14 Bolts(g), and
tighten using the Allen Key(o), see Figure 4.

2. Attach Soft Pad(t2) to the Grommet Base
Plate(m), see Figure 5.

3. Position the Pole(a) on the mounting
surface and secure using the Support Plate
(j), M10 Washer(k), Spring Washer(l) and
M10 Bolt(i). Fasten the M10 Bolt using
provided Wrench(p), see Figure 6.

Figure 4

t2

Figure 5

j

k

l

i

Figure 6