Doug Fleenor Designs PRE10-A Users Manual
PRESET 10 ARCHITECTURAL
OWNERS MANUAL
Doug Fleenor Design
396 Corbett Canyon Road
Arroyo Grande, CA 93420
(805) 481-9599
Software Version 2.4
Manual Revision 6
January , 2013
$ Serial # 085000
PRODUCT DESCRIPTION
The Preset 10 Architectural is a lighting control station capable of storing up to ten presets. These presets are recorded by
capturing the output of a DMX512 console. Each preset can then be assigned a unique fade time, from 0 to 999 seconds.
Presets are recalled by pressing one of the buttons.
System s can be created by using one or more stations and a power supply. The solid aluminum faceplate is designed to install
over a standard single gang electrical box. Connections to the Preset 10 Architectural are power (2 wires) and DMX512 (3
wires). Power for the Preset 10 can be supplied from a variety of sources, including a 10V class 2 “doorbell” transformer.
The Preset 10 Architectural system can work in conjunction with a lighting console, automatically switching between preset
and console control. When the console generates a DMX512 signal the Preset 1 0 Architectural goes off-line. The console then
operates normally. Upon loss of DMX512 from the console, the Preset 10 Architectural either returns to its pervious preset
or holds the last look (jumper selectable).
The Preset 10 system also comes in a portable version (model PRE10-P) that acts as a backup station for any DMX512 lighting
console or as a stand-alone DMX512 preset console.
Page 2 of 7
SPECIFICATIONS
Connector: Phoenix Contact MSTB series 5 position two part terminal block
Model: MSTB 2,5/5-ST-5,08 Order Number: 17 57 04 8
Connector pin out: (V) Supply voltage “hot”
(C) Supply common (internally tied to DMX512 common)
(+) DMX512 data +
( -) DMX512 data (C) DMX512 common
Input/Output Circuit: ESD protected EIA-485 transceiver (LT1785)
Indicators: Ten green preset indicator LEDs
One yellow Fade Time LED
One red Signal / Record LED
User controls: Ten preset push buttons
One recessed record push button
One recessed fade time push button
Option Jumpers: For a single station installation all jumpers should be installed. (see figure 1, page 5)
INSTALLED REMOVED
JP1 Recording Enabled Recording Disabled
JP2 Master Station Slave Station
JP3 Architectural Mode Portable Mode
JP4 Single Station Mode Multi Station Mode
Power input: 9 to 15 volts AC or DC, 200mA per station
(A 10 volt class 2 “doorbell” transformer is recommended for fixed installations)
Color: Black anodized with silver engraved nomenclature
Size : Faceplate: 4.5"h X 2.75"w X 0.2"d
Faceplate rear inset: 4.05"h X 2.4"w X 0.1"d
Electrical box m inim um inside dimensions: 3.5"h X 2.1"w X 1.25"d
Page 3 of 7
Loading...