Dormakaba 5715, 3000, 3035, 5750-K, 3125 Installation Manuals

Document Number 762.128
Rev. G — 05 / 2018

Installation Guide

Electronic
Entry Device

LA GARD Basic &
Gard Series

dormakaba

GENERAL INFORMATION

In order to maintain the highest quality standards and ensure a problem-free application, please read this guide thoroughly
before mounting the input unit. The installation instructions are the basis for Security Agency Approvals. The lock
installation must be done in accordance to these instructions in order to maintain the labeled approval level.

Keypad models 5715, 5750 and 5750-K are compatible with 4200 (solenoid) and 4200 (motor), 3800/3801/3802/3803
Firmware, 4300 (solenoid) and 4300M (motor), 6040 (solenoid) and 6040M (motor) High Security electronic locks. They
are also compatible with ComboGard Pro (39E) and AuditGard (66E) lock models and firmware.

SAFEGUARDS FOR MOUNTING

1. Once an electronic lock has been mounted, no more welding can be done on the safe.

2. Keep metal dust, filings, etc. away from the lock.

3. Keep cables away from sharp edges and moving parts.

4. Never carry keypads or locks by the cable.

5. Use 9-Volt ALKALINE batteries only. The use of a high quality, name brand battery (Energizer® or Duracell®) is
recommended.

BASIC TOOLS AND MATERIALS REQUIRED:

• Medium Phillips head screwdriver (#2) (recommend magnetized tip)

• Small flat file or deburring stone

• Tape measure or ruler

• ESD wrist band

PREPARATION FOR NEW INSTALLATION: IF REQUIRED

1. Use the template provided to establish the exact locations (relative to the spindle hole) of the mounting holes for the
Entry Device and the lock assembly. Be sure to consider the cable length from the entry device to the lock.

2. The spindle hole diameter can be a minimum of .406" (10.3mm) to a maximum of .438" (11.1mm). The .406" (10.3mm)
diameter is recommended. Spindle hole must be deburred.

3. The Entry Device mounting screws require drilled and tapped holes to 3/8" (9.5mm) depth if possible (minimum 1/4" or

6.4mm depth required.) Drill either the two horizontal mounting holes or the two vertical holes.

For Lock installation instructions, refer to 717.088 available at www.dormakaba.us.

SECURITY RECOMMENDATION:

Security relevant parts of a high security lock should not be accessible to unauthorized persons when the door of the secure
storage unit to which it is fitted is open.

(P/N) 762.128 Rev G 05/17 • © copyright 2009-2018 1

dormakaba

DIAL RINGFRONT HOUSING BASE MOUNTING TEMPLATE

(P/N) 762.128 Rev G 05/17 • © copyright 2009-2018 2