Donner Bath Furnishings CSI1329 Specification Sheet

Shower Rod Flanges

are stamped

61-F –Shower Rod Flange Set

s so that they are centered over rod outlines and

le, the following optional fasteners are

Plastic or Lead Anchors; Plaster/Drywall

Stock Number:

________________Shower Rod Flanges

Materials:

Installation Instructions:

Dimensions:

61

-

F

Shower Rods Technical Specification

Shower Rod Flange Set

Stock Numbers:

q

Polished Chrome Finish
Concealed Screw Mounting
Two Assemblies per Set
Fits 1” Diameter Rods

steel. Flange covers have a triple plated
polished chrome finish.

1. Position rod in shower opening in desired location.

2. Mark rod ends on walls.

3. Position bracket
mark mounting holes.

4. Drill starter holes.

5. Attach left bracket to wall using 1” screws (provided).

6. Slide left cover on left end of rod and mount on installed bracket.

7. Place right cover on right end of rod.

8. Insert right bracket into right end of rod.

9. Place end of rod in position and attach bracket to wall with 1”
screws (provided).

10. Snap covers into place over brackets.

Note: Wood blocking is preferable behind all wall surfaces.
If wood blocking is not availab
suggested: Tile/Masonry –
– Toggle Bolts

By Creative Specialties

25300 AL MOEN DRIVE •NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321- 8809 • FAX: [phone]
INTERNATIONAL: [phone] • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.CSI.MOEN.COM

Copyright Creative Specialties International 2006