Toothbrush and Soap Holders
are
P1740SS
–
Toothbrush Holder
Cleaning Instructions:
Stock Number:
________________Soap Dish & Tumbler
Materials:
Installation Instructions:
Dimensions:
Toothbrush & Soap Holder
P1740, P1760
Stainless Steel Technical Specification
Stock Numbers:
q
Stainless Steel Finish
Concealed Screw Mounting
q P1760SS – Soap Holder
Stainless Steel Finish
Concealed Screw Mounting
stamped from Type 304 stainless
steel.
1. Remove mounting bracket from back of fixture by loosening the set
screw.
2. Position unit on wall in desired location.
3. Lightly mark the outline of the base of the unit.
4. Center mounting bracket inside the outline.
5. Mark hole locations. Attach bracket to wall using 1 3/8” screws
(provided).
6. Mount base on bracket. Tighten set screw on the bottom.
Note: Wood blocking is preferable behind all wall surfaces.
If wood blocking is not available, the following optional fasteners are
suggested: Tile/Masonry – Plastic or Lead Anchors; Plaster/Drywall –
Toggle Bolts.
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
By Creative Specialties
25300 AL MOEN DRIVE •NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321-8809 • FAX: (800) 848-6636
INTERNATIONAL: (440) 962-2000 • FAX: (440) 962-2726
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: (888) 379-2720
WWW.CSI.MOEN.COM
Copyright Creative Specialties International 2006
Loading...