USER MANUAL
Model Name : Bluetooth Keyboard
DK-9201BI User Manual
VER: 0.1
MODEL NO. : DK-9201BI
VERSION : 0.1
DATE : 2012-3-14
Page 1 of 10
Version. # Revised Date PIC Remark
0.1 3/14/2012 Natural Preliminary
DK-9201BI User Manual
VER: 0.1
Page 2 of 10
Electrical Specification
1. Operating Voltage
Keyboard supply voltage: 1.8V-3.3V (2xAAA Batteries)
2. Current Consumption
Connecting Current: About 20mA
Usual use Current: < 5mA
DK-9201BI User Manual
VER: 0.1
3. Sleeping Mode
3.1 Timing to standby mode: 5S (The time from all keys are free to the keyboard turn to
sleeping mode)
3.2 Current during the sleeping mode :< 0.05mA (finally stable the current)
3.3 Wake up: press any key of the keyboard
4. Low-voltage indicate
When the voltage below 2.2V, the LED light was flashing 1Hz, which means the power is
low. (No action during sleeping model)
Wireless specifications
5
2.402-2.480GHz frequency coverage.
GFSK RF transceiver
High Speed RF link data rate Max. 1M bit/s
Page 3 of 10
Key Function Chart
1. The keys function as the figure shows (for Tablet)：
DK-9201BI User Manual
VER: 0.1
Page 4 of 10
Operation Process
Step 1
Open the battery cover which in the back of the keyboard.
Insert 2 AAA battery which is environment-friendly and safety
Close the battery cover.
Step 2
DK-9201BI User Manual
VER: 0.1
Operate your PC to find remote bluetooth device.
Step 3
Slide the power SW ON, Push the connect button to be found. Indicator Lamp is
twinkling。
Step 4
PC find the Bluetooth keyboard, Setup the device go by PC.
Step 5
Use the keyboard freely.
Page 5 of 10
DK-9201BI User Manual
VER: 0.1
Caution
Please use the keyboard in human house only and keep away
water.
Children use the keyboard with guardian together is necessary.
Keep dry. Humidity, liquids, contain minerals that will corrode
electronic circuits.
Don’t use or store in dusty, dirty areas.
Don’t store in hot areas. High temperature can shorten the life of
electronic devices and warp or melt certain plastics.
Don’t store in very cold areas. Moisture can form inside the case,
which may damage electronic circuit boards.
Don’t attempt to open the case. Non-expert handling of the device
may damage the system.
Avoid dropping and strong impact.
Page 6 of 10
DK-9201BI User Manual
VER: 0.1
FCC Statement
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for
help.
To assure continued compliance, any changes or modifications not
expressly approved by the party responsible for compliance
Page 7 of 10
DK-9201BI User Manual
VER: 0.1
could void the user’s authority to operate this equipment.
(Example- use only shielded interface cables when connecting to
computer or peripheral devices).
This equipment complies with Part 15 of FCC RF Rules.
Operation is subject to the following two conditions:
1) This device may not cause interference and
2) This device must accept any interference, including interference
that may cause undesired operation of the device.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment
1.This Transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
2.This equipment complies with FCC RF radiation exposure limits
set forth for an uncontrolled environment.
Caution!
The manufacturer is not responsible for any radio or TV
interference caused by unauthorized modifications to this
equipment. Such modifications could void the user authority to
operate the equipment.
Page 8 of 10
DK-9201BI User Manual
VER: 0.1
Canada Statement
This device complies with Industry Canada RSS-210.
Operation is subject to the following two conditions: (1) this
device may not cause interference, and(2) this device must
accept any interference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie
Canada applicables aux appareils radio RSS-210.
L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioé
lectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
The device meets the exemption from the routine evaluation
limits in section 2.5 of RSS 102 and compliance with
RSS-102 RF exposure, users can obtain Canadian
information on RF exposure and compliance.
Le dispositif rencontre l'exemption des limites courantes
d'évaluation dans la section 2.5 de RSS 102 et la conformité
Page 9 of 10
DK-9201BI User Manual
VER: 0.1
à l'exposition de RSS-102 rf, utilisateurs peut obtenir
l'information canadienne sur l'exposition et la conformité
de rf.
CONTACT
Dongguan Siliten Electronics CO.,LTD
Jiezhou Second Industrial Park，Shijie Town ，Dongguan City ，
Guangdong Province ，China
Page 10 of 10
Loading...