Dongguan Newmen Electronics Technology MS 270OR User Manual

Wireless Mouse

2.4GHz wireless technology

Installing the battery
Mouse

Whenever new battery is installed, make sure that it is fresh 1.5V AA
battery.
A)Remove the battery cover.
B) Insert one AA battery into the battery compartment, make sure to
properly orient the positive (+) and negative (-) ends as specified by
the marks in the battery compartment. Replace the battery cover and
make sure it is locked.

User Manual

MS-270OR

"ON/OFF" switch
Without using the mouse, user may turn off it by "ON/OFF" switch for
saving battery power.

Left Button Right Button

Scroll Wheel

Receiver

(1) (2) (3)

Installing the receiver

The codes of receiver and mouse were successfully connected in factory.
User can directly use the complete set of products, no worry about the
code connecting.
Insert receiver into USB port of PC, the computer system will automatically
detect it and prepare it for full operation.

If the user wrongly operates, please redo the above operating procedures.

System requirements

Windows 2000/XP/Vista/Win7/Win8/Win8.1/Win10/Mac
Hardware requirements: IBM and PC compatible

FCC STATEMENT :

This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However,there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:

Reorient or relocate the receiving antenna.
　 Increase the separation between the equipment and receiver.
　 Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

　 Consult the dealer or an experienced radio/TV technician for help.