Donaldson P290017 User Manual

Installation Instructions

for Wireless Sensor Kit X220106

CAUTION

Turn off equipment before

inspecting, removing or

installing an indicator

or sensor.

X220106 Kit Contents

Qty. Part number Description

1 P290025 Instruction manual

1 X220104

1

1

3

Application
The Wireless Air Sensor is part of the
Donaldson Intelligent Filtration System. The
system is intended to be installed on both
on-road and off-road equipment requiring
predictive air filter maintenance. The Wireless
Air Sensor and Easy Receiver are meant to be
installed in conjunction with a GEOTAB GO
device 7, 8, or 9.

Tools

P290020

P290024

P290021

• 7/16," 1/2," or 5/8" wrench (depends on

existing fitting size) — for air fittings

• Diagonal cutters — for trimming zip ties.

Wireless Air
Pressure Sensor 

Easy Receiver 

Cable 

Zip Tie 







Wireless Air Sensor Install

1. Locate the air filter housing.

2. If present, remove the visual indicator from the filter.



Existing visual

indicator

Materials

Teflon Tape

3. A tee fitting may be used to install the wireless sensor while retaining the use

of an existing indicator. The use of a Tee fitting is recommended when a wired
sensor or switch is present. Removing a wired sensor from the system may
cause a fault condition.

The Safety Alert Symbol indicates a hazardous situation which, if not avoided could result in death or serious injury.
Obey all safety messages following this symbol to avoid possible injury or death. The possible hazards are explained in
the associated text messages.

This manual contains specific precautions related to worker safety. The hazard alert image denotes safety related
instructions and warnings in this manual. DO NOT install, operate, or perform maintenance on this wireless sensor kit until you have
read and understood the instructions, precautions and warnings contained within this manual.

4. Place Teflon tape on the fitting prior to installing the sensor.

Teflon tape

5. Install the wireless sensor in place of the existing indicator or tee

fitting.

X22010 Wireless Sensor

Thread the wireless air sensor on the fitting and torque hand-tight.

Do not overtighten.

GEOTAB device

Note: Depending on the application, extra fittings may be required

to complete the installation.

Easy Receiver Install

7. Locate the GEOTAB device.

8. Remove the dust cover on the GEOTAB device.

GEOTAB device dust cover