Dometic CK 155 Inlstruction For Use

825 12 01-02

Model CK 155

Instruction for use

1

2

1 Hole for hose in shelf, if any.
2 Recess for installation under wall cupboard.
3 From the fan.
4 From battery.
5 Fuse holder with a T4 A fuse 5x20 mm.

Spare part number for fuse: 762 82 13-91.

6 White
7 Black
8 Red

e5

020074

Type: CK

C

B

A

3

7

4

5

6

6

7

8

D

105 mm

25 170

130

6

Controls The fan filter

The fan filter that absorbs grease in cooking fumes re­quires cleaning now and then, how often depends on
how much the cooker is used and for how much the fan
is in operation.
Do not wait until the suction power of the fan begins to
decrease noticeably.
Cleaning can easily be carried out with hot water to which
some synthetic detergent has been added.

Technical data

Motor power 30 W
Voltage 12 V
Capacity 125 m3/h
Light 2x 10W, 12V GU4

MO-FO 0246

Placing

The ventilator is for use in caravans, motorhomes and
boats and designed to be placed above the food prepa­ration area, preferably under an existing top cupboard.

The distance from the gas-stove flame to the lower edge
of the cooker hood must not be less than 46 cm.

The ventilator part A-B-C should be placed in the roof,
on a surface that is as even and horizontal as possible.
If the ventilator is positioned on a sloping surface, the
part A should be rotated so that one of the three drain­age openings points downwards. An inclination of up to
20° is acceptable without reducing the ventilation when
the motor is running.

Fitting the ventilator

Make a hole with a diameter of 105 mm through the roof
of the vehicle.
Place the ventilator part A in the hole and make a mark
of the six screw holes.
Remove part A and apply a thin ring of some perma­nently plastic sealing compound around each hole.
Put the rubber ring into the groove underneath of part A.

It is important that the lower part should be firmly tight­ened so that the rubber gasket fits closely against the
roof.

Fasten the hood B in the lower part A.
Then fasten the upper part C in the lower part A.

Make a hole in the bottom of the cupboard as shown on
the dimension sketch 2.
To reach the mounting holes pull out the lamps.
Fasten the ventilator hood D with screws and fit the hose
to the fan and hood, tighten the hose with the hose clips.
Connect the fan to the battery according to the figure.

Lighting: ON/OFF

Fan motor: ON/OFF

Speed: Half/Full