Dome DMWS1 Installation Manual
LED Indicator
Metal Feet
Leak Sensor
Thank you for purchasing the DOME
Leak Sensor, which works with your Z-Wave Certified Controller to monitor your home for leaks
and for rising water levels in your sump pump.
Cradle
Lead
Figure 1 - Leak Sensor Front
Remote Sensor
Including/Connecting into the Z-Wave Network:
Follow the instructions for your Z-Wave certified Controller to
enter inclusion mode.
When prompted by the Controller:
1. For proper inclusion, bring the Leak Sensor to within 10 feet
of your Controller. After inclusion, the device can be moved
to any desired location.
2. Remove the cover of the Leak Sensor by twisting it apart
(Fig 3.)
3. Remove the Battery Tab.
4. Press the Connect Button quickly 3 times in a row.
The LED Indicator will flash five times indicating inclusion.
Twist Counter-Clockwise
to Open
Connect Button
Battery Tab
Battery
Figure 2 - Opening the Leak Sensor
LED Indicator
Excluding/Disconnecting from the Z-Wave Network:
Follow the instructions for your Z-Wave certified Controller to
enter exclusion mode.
When prompted by the Controller:
1. Remove the Cover of the Leak Sensor.
2. Press the Connect Button quickly 3 times in a row.
The LED Indicator will flash five times indicating exclusion/disconnection.
Resetting the Leak Sensor to Factory Default Settings:
To disconnect from the Z-Wave Network and restore factory default
settings:
1. Open the Back Plate and make sure the Leak Sensor is
powered.
2. Hold the Connect Button for 10 seconds until the LED Indicator
blinks once, then release the button.
Only do this if the controller is disconnected or otherwise unreachable!
How to Use—Without Cradle:
You can use the Leak Sensor to monitor most appliances and pipes for leaks without the cradle. Once
included in your Z-Wave system, place the Leak Sensor
on a flat surface near the item you want monitored
where water will collect if it leaks. Make sure all three
Metal Feet are touching the surface.
Metal Feet
Figure 4 - Showing the
Metal Feet
When water contacts the
Metal Feet, it will beep
and send an alert to your
Z-Wave Controller notifying
it of the detected water.
Leaking Water
Figure 3 - Using the Sensor
Without the Cradle
Sensor
How to Use—With Cradle:
To use the cradle, place the sensor into the Cradle,
making sure the Metal Feet make full contact with the
Metal Contacts. It can be placed on a surface or mounted on a wall using the included hardware. The Remote
Sensor Probe plugs into the Cradle through the 3.5mm
minijack.
Figure 5 - The Cradle
How to Use—Installing with the Cradle and Remote Sensor:
To use the
Leak Sensor in
hard-to-reach
areas, mount the
Appliance
Sensor in Cradle
Cradle on a nearby
wall and place the
Remote Sensor in
the area you want
monitored. Make
sure the sensor is
Lead
laying flat with its
Metal Feet making
Remote Sensor
full contact with the
floor or surface.
Figure 6 - Using the Remote Sensor
How to Use—Installing with the Cradle and Remote Sensor:
To monitor the water
level in your sump
Sensor in Cradle
pump pit, mount the
Cradle on a nearby
wall and suspend the
Lead
Remote Sensor in the
pit 5 inches below the
lid. Suspending the
Remote Sensor
Remote Sensor in the
pit allows you to get a
notification before the
Sump Pump
Pit
water starts to overflow
the pit.
Figure 7 - Using the
Remote Sensor in a Sump Pump
If you have questions, our trained Customer Service Department is happy to assist
you 24 hours a day, 7 days a week. Contact Dome Customer Service as follows: • In
North America dial: 1-855-249-1754 • Email Dome at support@domeHA.com
DO NOT RETURN THIS PRODUCT TO THE STORE OR WEBSITE FROM WHICH IT WAS
PURCHASED If you believe the product is defective, has a missing or broken part
or are having difficulty with it please contact Dome as listed above for a quick and
efficient solution to the problem.
Legal Notices: This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following
measures: Reorient or relocate the receiving antenna; increase the separation
between the equipment and the receiver; connect the equipment into an outlet on a
circuit different from that to which the receiver is connected. Consult the dealer or
an experienced radio/TV technician for help.
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
NEED HELP? CONTACT DOME CUSTOMER SERVICE
1 Year Limited Warranty
Elexa Consumer Products, Inc. (”ECP”) warrants to the original retail purchaser (”Purchaser”) that the DOME Siren (the “Product”)
will be free of defects in materials or workmanship under use for one (1) year from the
date of purchase (the “Warranty period”).
For the Purchaser only, if the Product fails to
perform as specified during the Warranty Period due to defective parts or faulty workmanship, ECP will repair or replace the defective
or damaged parts of the Product. Normal wear
and tear is not covered nor is abnormal use,
misuse, mishandling, faulty installation, improper shipping, damage caused by disasters
such as fire, flood or earthquake, neglect, accident or tampering. This warranty covers only
normal use in the United States or Canada.
To obtain warranty service during the Warranty
Period, call Dome Customer Service (1-855-
249-1754) or email: support@domeHA.com for
instructions on sending damaged parts and
documentation for a Return Material Authorization (RMA). Products returned to ECP for repair or replacement without authorization will
be returned at the sender’s expense. All warranty claims must be accompanied by a legible
copy of the original receipt showing date and
details of purchase. The RMA number must
be clearly written on the side of the shipping
container in which you return the Product or
defective parts. Unless otherwise instructed by
ECP, the Product must be sent freight pre-paid
to the following address:
Elexa Consumer Products, c/o Promac,
1153 Timber Dr., Elgin, IL 60123
ECP will repair or replace the defective parts
and return them at ECP’s cost by a shipping
method selected by ECP. When contacting
ECP to obtain an RMA, Purchaser may request
expedited return shipping at Purchaser’s expense.
THIS WARRANTY IS NOT TRANSFERABLE,
AND, TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW IS IN LIEU OF ALL
OTHER WARRANTIES, REPRESENTATIONS
AND CONDITIONS, EXPRESSED OR IMPLIED,
STATUTORY OR OTHERWISE, INCLUDING BUT
NOT LIMITED TO THE IMPLIED WARRANTIES
OF MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE. NO OTHER PERSON
OR REPRESENTATIVE IS AUTHORIZED TO
MAKE ANY OTHER WARRANTY ON BEHALF
OF ECP OR ASSUME FOR ECP ANY OTHER
LIABILITY IN CONNECTION WITH THE SALE
OF THIS PRODUCT. IN NO EVENT WILL ECP
BE LIABLE FOR ANY DAMAGES, INCLUDING
BUT NOT LIMITED TO INCIDENTAL, SPECIAL
OR CONSEQUENTIAL DAMAGES ARISING OUT
OF THE USE OR INABILITY TO USE THE PRODUCT, INCLUDING DAMAGES DUE TO ECP’S
NEGLIGENCE.
THIS WARRANTY GIVES YOU SPECIFIC LEGAL
RIGHTS, AND YOU MAY ALSO HAVE OTHER
RIGHTS WHICH VARY FROM STATE TO STATE
AND COUNTRY TO COUNTRY.
This marking on the product, accessories or literature indicates that the product
and its electronic accessories should not be disposed of with other household waste.
To prevent possible harm to the environment or human health from uncontrolled
waste disposal, please separate these items from other types of waste and recycle
them responsibly to promote the sustainable reuse of material resources.
Household users should contact either the retailer where they purchased this
product, or their government office, for details of where and how they can take these
items for environmentally safe recycling.
Business users should contact their supplier and check the terms and conditions
of the purchase contract. This product and its electronic accessories should not be
mixed with other wastes for disposal.
This marking on the battery, manual or packaging indicates that the batteries in
this product should not be disposed of with other household waste. Where marked,
the chemical symbols Hg, Cd or Pb indicate that the battery contains mercury,
cadmium or lead above the reference levels in EC Directive 2006/66. If batteries are
not properly disposed of, these substances can cause harm to human health or the
environment.
CORRECT DISPOSAL OF BATTERIES IN THIS PRODUCT
#Z52NAS-WS01Z
©2016 Elexa Consumer Products, Inc.
2275 Half Day Rd., Suite 333
Bannockburn, IL 60015
www.domeHA.com
Loading...